Specification sheet Wheel Loader Ref zettelmeyer-zl8c-wheel-loader

Zettelmeyer ZL8C

The Zettelmeyer ZL8C is a wheel loader with an operating weight of 6,459.55 lb (2,930 kg), a 34.87 hp engine, and a 0.53 yd³ (0.4 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,459.55lb
2,930kg
Engine power
34.87hp
26kW
Gross Power
Bucket capacity
0.53yd³
0.4m³

Where it sits in its classpercentile · compact wheel loaders

Among 374 compact wheel loaders (≤22,000 lb), the Zettelmeyer ZL8C sits at the compact end of its class:

  • Operating weight 6,460 lb lighter than 93% (n=374)
  • Engine power 35 hp less powerful than 95% (n=367)
  • Bucket capacity 0.5 yd³ smaller-bucket than 96% (n=309)

Scale drawingdrawn to scale · mm

2495B285C4330A
Side elevation
2495B1660D
Front elevation

01 Engine Specification

Number Of Cylinders 2
Engine Make 2349
Gross Power 34.9hp 26kw
Power Measured @ 3000rpm
Aspiration natural

02 Operational Specification

Operating Weight 6459.6lb 2930kg
Fuel Capacity 11.9gal 45L
Hydraulic System Fluid Capacity 11.9gal 45L
Static Tipping Weight 5247.1lb 2380kg
Turning Radius 11.5ft in 3500mm
Operating Voltage 12V
Rear Axle Oscillation 25degrees
Tire Size 10.5-18

03 Transmission Specification

Transmission Type hydrostatic, reversibe and shiftable
Max Speed - Forward 11.9mph 19km/h

04 Hydraulic System Specification

Relief Valve Setting 2610.7psi 18000kPa
Raise Time 6sec
Lower Time 6.5sec
Pump Type gear pump

05 Bucket Dimensions

Dump Clearance At Max Raise 7.17ft in 2185mm
Bucket Capacity - Heaped 0.53yd3 0.4m3
Bucket Capacity - Struck 0.42yd3 0.32m3
Bucket Width 5.42ft in 1650mm
Breakout Force 562022.31lb 2500kN

06 Dimensions Dimensions

Ground Clearance 0.94ft in 285mm
Length With Bucket On Ground 14.21ft in 4330mm
Width Over Tires 5.45ft in 1660mm
Height To Top Of Cab 8.19ft in 2495mm
Wheelbase 5.91ft in 1800mm
Hinge Pin - Max Height 8.86ft in 2700mm
Reach At Max Lift And Dump 1.89ft in 575mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.