The Yanmar S190R-1 is a skid steer loader with an operating weight of 6,880.63 lb (3,121 kg), a 68.4 hp engine, a rated operating capacity of 1,900.4 lb (862 kg), and a tipping load of 3,800.8 lb (1,724.02 kg).
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Yanmar S190R-1 sits in the middle of its class:
Operating weight6,880 lbheavier than 52%(n=334)
Engine power68 hpmore powerful than 56%(n=335)
Rated operating capacity1,900 lblower-rated than 51%(n=288)
◇Scale drawingdrawn to scale · mm
Side elevationFront elevation
01 Engine Specification
Engine Make
Yanmar
Engine Model
4TNV98C-NMS
Net Power
68.4hp
51kw
Power Measured @
2500rpm
Displacement
202.6cu in
3.4L
02 Capacities Specification
Rated Operating Capacity
1900.4lb
862kg
03 Operational Specification
Operational Weight
6880.7lb
3121kg
Fuel Capacity
16.6gal
62.5L
Max Speed
12.5mph
20km/h
Tire Size
10.00 x 16.5 HD
04 Electrical Specification
Alternator
95amps
Starter Size
12-volt (3.0 kW)
Battery
12-volt (950 CCA)
05 Weights Specification
With Optional Counterweight
2109.9lb
957kg
06 Loader Specification
Bucket Width
66in
1676mm
07 Hydraulic Specification
Hydraulic Reservoir
11gal
41.6L
Auxiliary Hydraulic Flow
18.5gal/min
70.1L/min
Pump Flow Capacity
31.5gal/min
119.3L/min
Relief Valve Pressure
3000psi
20684.3kPa
08 Dimensions Dimensions
A Length With Bucket
10.59ft in
3226mm
D Ground Clearance
6.5in
165mm
C Height To Top Of Cab
13.17ft in
4013mm
Wheelbase
3.51ft in
1067mm
B Length W/O Bucket
7.84ft in
2388mm
Reach At Max Lift And Dump
22.52in
572mm
Hinge Pin Height - Fully Raised
120.52in
3061mm
Dump Angle
42degrees
Front Departure Angle
25degrees
Overall Height, Rops Cab
80in
2032mm
E Overall Width
5.38ft in
1638mm
Rollback - Ground Level
26degrees
Ground Height
39.02in
991mm
Dump Height
7.59ft in
2311mm
Data notes
†
Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.