The Yanmar S165R-1 is a skid steer loader with an operating weight of 6,122.24 lb (2,777 kg), a 68.4 hp engine, a rated operating capacity of 1,649.1 lb (748 kg), and a tipping load of 3,300.4 lb (1,497.04 kg).
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Yanmar S165R-1 sits below the median for its class:
Operating weight6,120 lblighter than 68%(n=334)
Engine power68 hpmore powerful than 56%(n=335)
Rated operating capacity1,650 lblower-rated than 65%(n=288)
◇Scale drawingdrawn to scale · mm
Side elevationFront elevation
01 Engine Specification
Engine Make
Yanmar
Engine Model
4TNV98C-NMS2
Net Power
68.4hp
51kw
Power Measured @
2800rpm
Displacement
201.4cu in
3.3L
02 Capacities Specification
Rated Operating Capacity
1649.1lb
748kg
03 Operational Specification
Operational Weight
6122.3lb
2777kg
Fuel Capacity
16.6gal
62.5L
Max Speed
7.1mph
11.3km/h
Tire Size
10.00 x 16.5 HD
04 Electrical Specification
Alternator
100amps
Starter Size
12-volt (2.3 kW)
Battery
12-volt (950 CCA)
05 Weights Specification
With Optional Counterweight
1799lb
816kg
06 Loader Specification
Bucket Width
61.5in
1562mm
07 Hydraulic Specification
Hydraulic Reservoir
11gal
41.7L
Auxiliary Hydraulic Flow
18.9gal/min
71.5L/min
Relief Valve Pressure
3000psi
20684.3kPa
08 Dimensions Dimensions
A Length With Bucket
10.18ft in
3101mm
D Ground Clearance
6.3in
160mm
C Height To Top Of Cab
12.72ft in
3876mm
Wheelbase
3.25ft in
988mm
B Length W/O Bucket
7.83ft in
2385mm
Reach At Max Lift And Dump
32.8in
833mm
Hinge Pin Height - Fully Raised
119.02in
3023mm
Dump Angle
38degrees
Front Departure Angle
21degrees
Overall Height, Rops Cab
76.7in
1948mm
E Overall Width
5.27ft in
1605mm
Rollback - Ground Level
28degrees
Ground Height
35.6in
904mm
Dump Height
7.81ft in
2380mm
Data notes
†
Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.