Specification sheet Wheel Loader Ref wacker-neuson-wl37-wheel-loader

Wacker Neuson WL37

The Wacker Neuson WL37 is a wheel loader with an operating weight of 8,223 lb (3,729.9 kg), a 74 hp engine, and a 0.78 yd³ (0.6 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,223lb
3,729.9kg
Engine power
74hp
55.19kW
Gross Power
Bucket capacity
0.78yd³
0.6m³

Where it sits in its classpercentile · compact wheel loaders

Among 374 compact wheel loaders (≤22,000 lb), the Wacker Neuson WL37 sits at the compact end of its class:

  • Operating weight 8,220 lb lighter than 86% (n=374)
  • Engine power 74 hp more powerful than 53% (n=367)
  • Bucket capacity 0.8 yd³ smaller-bucket than 90% (n=309)

Scale drawingdrawn to scale · mm

2310B297C4126A
Side elevation
2310B1560D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make Deutz
Engine Model TD2011 L04w
Gross Power 74hp 55.2kw
Power Measured @ 2300rpm
Displacement 221cu in 3.7L
Alternator 95amps

02 Capacities Specification

Front Axle 244.1cu in 4L
Hydraulic Oil Tank 17.2gal 65L
Coolant (Engine) 2.7gal 10L
Fuel Tank 14.6gal 55L
Rear Axle 1.3gal 4.7L
Hydraulic System 19.9gal 75L
Engine Oil 2.8gal 10.5L

03 Operational Specification

Max Speed 4.4mph 7.1km/h
Operating Voltage 12V

04 Weights Specification

Lifting Force Maximum 8331lb 3778.9kg
Breakout Force Maximum 8783lb ft 11908.2Nm
Operating Weight 8223lb 3729.9kg

05 Hydraulic System Specification

Pump Flow Capacity 34gal/min 128.8L/min
Relief Valve Pressure 6527psi 45002.1kPa

06 Bucket Dimensions

Dumping Angle, Top 40degrees
Bucket Capacity - Heaped 0.78yd3 0.6m3

07 Dimensions Dimensions

Ground Clearance 0.98ft in 297mm
Length With Bucket On Ground 13.54ft in 4126mm
Width Over Tires 5.12ft in 1560mm
Height To Top Of Cab 7.58ft in 2310mm
Wheelbase 6.63ft in 2020mm
Overall Length 16.28ft in 4960mm
Track Width 47.25in 1200mm
Turning Radius 5.5ft in 1674mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.