Specification sheet Wheel Loader Ref wacker-neuson-wl30-wheel-loader
Wacker Neuson WL30
The Wacker Neuson WL30 is a wheel loader with an operating weight of 6,856.38 lb (3,110 kg), a 48 hp engine, and a 0.59 yd³ (0.45 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
6,856.38lb
3,110kg
Engine power
48hp
35.8kW
Gross Power Bucket capacity
0.59yd³
0.45m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Wacker Neuson WL30 sits at the compact end of its class:
- Operating weight 6,860 lb lighter than 92% (n=374)
- Engine power 48 hp less powerful than 83% (n=367)
- Bucket capacity 0.6 yd³ smaller-bucket than 94% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2351 | |
| Engine Model | 404 C-22 | |
| Gross Power | 48hp | 35.8kw |
02 Operational Specification
| Operating Weight | 6856.4lb | 3110kg |
|---|---|---|
| Fuel Capacity | 14.1gal | 53L |
| Hydraulic System Fluid Capacity | 8.5gal | 32L |
| Static Tipping Weight | 4438lb | 2013kg |
| Turning Radius | 10.3ft in | 3138mm |
| Rear Axle Oscillation | 24degrees |
03 Transmission Specification
| Transmission Type | Hydrostatic | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Max Speed - Forward | 12.4mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3045psi | 20994.6kPa |
|---|---|---|
| Pump Flow Capacity | 13gal/min | 49L/min |
| Pump Type | Gear pump |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 7.93ft in | 2416mm |
|---|---|---|
| Bucket Capacity - Heaped | 0.59yd3 | 0.45m3 |
| Breakout Force | 9089lb | 40.43kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 14.95ft in | 4554mm |
|---|---|---|
| Width Over Tires | 4.42ft in | 1345mm |
| Height To Top Of Cab | 7.39ft in | 2251mm |
| Wheelbase | 5.69ft in | 1732mm |
| Hinge Pin - Max Height | 10.53ft in | 3209mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.