Specification sheet Wheel Loader Ref wacker-neuson-wl18-wheel-loader
Wacker Neuson WL18
The Wacker Neuson WL18 is a wheel loader with an operating weight of 4,056.51 lb (1,840 kg), a 24.8 hp engine, and a 0.27 yd³ (0.2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
4,056.51lb
1,840kg
Engine power
24.8hp
18.5kW
Gross Power Bucket capacity
0.27yd³
0.2m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Wacker Neuson WL18 sits at the compact end of its class:
- Operating weight 4,060 lb lighter than 98% (n=374)
- Engine power 25 hp less powerful than 99% (n=367)
- Bucket capacity 0.3 yd³ smaller-bucket than 99% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 3 | |
|---|---|---|
| Engine Make | 2351 | |
| Engine Model | 403C-11 | |
| Gross Power | 24.8hp | 18.5kw |
02 Operational Specification
| Operating Weight | 4056.6lb | 1840kg |
|---|---|---|
| Fuel Capacity | 5.6gal | 21L |
| Hydraulic System Fluid Capacity | 4.8gal | 18L |
| Static Tipping Weight | 2017.3lb | 915kg |
| Turning Radius | 8.4ft in | 2540mm |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 27x10.5-15 EM (earthmoving) |
03 Transmission Specification
| Transmission Type | hydrostatic all-wheel drive with automotive style control |
|---|
04 Hydraulic System Specification
| Relief Valve Setting | 2828psi | 19498.4kPa |
|---|---|---|
| Pump Flow Capacity | 8.7gal/min | 33L/min |
| Pump Type | gear pump |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 6.73ft in | 2050mm |
|---|---|---|
| Bucket Capacity - Heaped | 0.27yd3 | 0.2m3 |
| Breakout Force | 2792lb | 12.42kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 11.37ft in | 3465mm |
|---|---|---|
| Width Over Tires | 3.47ft in | 1055mm |
| Height To Top Of Cab | 6.06ft in | 1845mm |
| Wheelbase | 4.42ft in | 1345mm |
| Hinge Pin - Max Height | 8.97ft in | 2734mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.