Specification sheet Wheel Loader Ref wacker-neuson-5055-wheel-loader
Wacker Neuson 5055
The Wacker Neuson 5055 is a wheel loader with an operating weight of 7,936.6 lb (3,599.99 kg), and a 47 hp engine.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
7,936.6lb
3,599.99kg
Engine power
47hp
35.1kW
Net Power ◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Wacker Neuson 5055 sits at the compact end of its class:
- Operating weight 7,940 lb lighter than 87% (n=374)
- Engine power 47 hp less powerful than 86% (n=367)
Not positioned on bucket capacity — withheld or unpublished for this machine.
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | Yanmar | |
|---|---|---|
| Net Power | 47hp | 35.1kw |
| Displacement | 133.6cu in | 2.2L |
02 Operational Specification
| Payload | 3527.4lb | 1600.1kg |
|---|---|---|
| Operating Weight | 7936.6lb | 3600kg |
| Fuel Capacity | 15.6gal | 59.1L |
| Hydraulic System Fluid Capacity | 61.3gal | 232.1L |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 55amps | |
| Tire Size | 10.5-18 |
03 Transmission Specification
| Travel Speed | 12.4mph | 20km/h |
|---|
04 Hydraulic System Specification
| Relief Valve Setting | 3481 psi | |
|---|---|---|
| Pump Flow Capacity | 22.2gal/min | 84.1L/min |
05 Bucket Dimensions
| Bucket Width | 5.42ft in | 1650mm |
|---|---|---|
| Breakout Force | 6294.6lb | 28kN |
| Tipping Load Standard Bucket | 4761.9lb | 2159.97kg |
06 Dimensions Dimensions
| Ground Clearance | 0.89ft in | 270mm |
|---|---|---|
| Length With Bucket On Ground | 16.25ft in | 4950mm |
| Width Over Tires | 5.22ft in | 1590mm |
| Height To Top Of Cab | 7.81ft in | 2380mm |
| Wheelbase | 6.07ft in | 1850mm |
| Hinge Pin - Max Height | 9.98ft in | 3040mm |
| Reach At Max Lift And Dump | 0.99ft in | 300mm |
| Center Edge To Center Of Front Axle | 5.84ft in | 1780mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.