Specification sheet Skid Steer Loader Ref volvo-mc90b-skid-steer-loader

Volvo MC90B

The Volvo MC90B is a skid steer loader with an operating weight of 6,985 lb (3,169 kg), a 80.5 hp engine, a rated operating capacity of 2,000 lb (907 kg), and a tipping load of 4,016 lb (1,821.63 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,985lb
3,169kg
Engine power
80.5hp
60kW
Net Power
Rated operating capacity
2,000lb
907kg
Tipping load
4,016lb † — value reconstructed from related published figures
1,821.63kg
Bucket capacity
0.7yd³
0.6m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Volvo MC90B sits in the middle of its class:

  • Operating weight 6,990 lb heavier than 56% (n=334)
  • Engine power 81 hp more powerful than 81% (n=335)
  • Rated operating capacity 2,000 lb higher-rated than 56% (n=288)

◇Scale drawingdrawn to scale · mm

2069C236D3503A2877B
Side elevation
2069C1836E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2244
Engine Model D3.4A
Gross Power 82.6hp 61.6kw
Net Power 80.5hp 60kw
Aspiration Turbocharged
Displacement 201cu in 3.3L

02 Operational Specification

Operational Weight 6985lb 3169kg
Fuel Capacity 23gal 87L
Cooling System Fluid Capacity 4.1gal 15.5L
Engine Oil Fluid Capacity 2.9gal 11L
Hydraulic System Fluid Capacity 25.7gal 97.3L
Max Speed 6.7mph 10.8km/h
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 2000lb 907kg
Bucket Capacity 0.7yd3 0.6m3

04 Hydraulic Specification

Pump Flow Capacity 20.3gal/min 76.9L/min
Relief Valve Pressure 2700psi 18615.9kPa

05 Dimensions Dimensions

Length With Bucket 11.5ft in 3503mm
Width Over Tires 6.03ft in 1836mm
Ground Clearance 9.3in 236mm
Height To Top Of Cab 6.79ft in 2069mm
Wheelbase 3.52ft in 1070mm
Length W/O Bucket 9.44ft in 2877mm
Clearance At Max Lift And Dump 7.66ft in 2332mm
Reach At Max Lift And Dump 22.29in 566mm
Turning Radius From Center - Machine Rear 56.23in 1428mm
Turning Radius From Center - Inc Bucket 92.5in 2349.5mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.