Specification sheet Skid Steer Loader Ref volvo-mc80b-skid-steer-loader

Volvo MC80B

The Volvo MC80B is a skid steer loader with an operating weight of 6,824 lb (3,096 kg), a 65.2 hp engine, a rated operating capacity of 1,850 lb (839 kg), and a tipping load of 3,770 lb (1,710.05 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,824lb
3,096kg
Engine power
65.2hp
48.6kW
Net Power
Rated operating capacity
1,850lb
839kg
Tipping load
3,770lb † — value reconstructed from related published figures
1,710.05kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Volvo MC80B sits in the middle of its class:

  • Operating weight 6,820 lb heavier than 50% (n=334)
  • Engine power 65 hp more powerful than 52% (n=335)
  • Rated operating capacity 1,850 lb lower-rated than 54% (n=288)

◇Scale drawingdrawn to scale · mm

2069C236D3504A2877B
Side elevation
2069C1836E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2244
Engine Model D3.4A
Gross Power 67.3hp 50.2kw
Net Power 65.2hp 48.6kw
Aspiration Natural
Displacement 201cu in 3.3L

02 Operational Specification

Operational Weight 6824lb 3096kg
Fuel Capacity 23gal 87L
Cooling System Fluid Capacity 4.1gal 15.5L
Engine Oil Fluid Capacity 2.9gal 11L
Hydraulic System Fluid Capacity 25.7gal 97.3L
Max Speed 6.3mph 10.2km/h
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 1850lb 839kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 20.3gal/min 76.7L/min
Relief Valve Pressure 2700psi 18615.9kPa

05 Dimensions Dimensions

Length With Bucket 11.5ft in 3504mm
Width Over Tires 6.03ft in 1836mm
Ground Clearance 9.3in 236mm
Height To Top Of Cab 6.79ft in 2069mm
Wheelbase 3.34ft in 1018mm
Length W/O Bucket 9.44ft in 2877mm
Clearance At Max Lift And Dump 7.66ft in 2332mm
Reach At Max Lift And Dump 23.31in 592mm
Turning Radius From Center - Machine Rear 57.64in 1464mm
Turning Radius From Center - Inc Bucket 91.26in 2318mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.