Specification sheet Skid Steer Loader Ref volvo-mc70b-skid-steer-loader

Volvo MC70B

The Volvo MC70B is a skid steer loader with an operating weight of 5,801 lb (2,632 kg), a 53 hp engine, a rated operating capacity of 1,500 lb (680 kg), and a tipping load of 3,004 lb (1,362.59 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,801lb
2,632kg
Engine power
53hp
39.5kW
Net Power
Rated operating capacity
1,500lb
680kg
Tipping load
3,004lb † — value reconstructed from related published figures
1,362.59kg
Bucket capacity
0.6yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Volvo MC70B sits below the median for its class:

  • Operating weight 5,800 lb lighter than 72% (n=334)
  • Engine power 53 hp less powerful than 69% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

1990C208D3306A2688B
Side elevation
1990C1656E
Front elevation

01 Engine Specification

Engine Make 2244
Engine Model D2.0A
Gross Power 57.2hp 42.7kw
Net Power 53hp 39.5kw
Aspiration Turbocharged
Displacement 122cu in 2L

02 Operational Specification

Operational Weight 5801lb 2632kg
Cooling System Fluid Capacity 2.4gal 9L
Engine Oil Fluid Capacity 2.4gal 9L
Max Speed 7.5mph 12.1km/h
Hydraulic System Fluid Capacity 15gal 56.8L
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 1500lb 680kg
Bucket Capacity 0.6yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 17.1gal/min 64.8L/min

05 Dimensions Dimensions

Length With Bucket 10.85ft in 3306mm
Width Over Tires 5.44ft in 1656mm
Ground Clearance 8.19in 208mm
Height To Top Of Cab 6.53ft in 1990mm
Wheelbase 3.37ft in 1026mm
Length W/O Bucket 8.82ft in 2688mm
Clearance At Max Lift And Dump 7.19ft in 2190mm
Reach At Max Lift And Dump 25.44in 646mm
Turning Radius From Center - Machine Rear 55in 1398mm
Turning Radius From Center - Inc Bucket 85.5in 2172mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.