Specification sheet Skid Steer Loader Ref volvo-mc110b-skid-steer-loader

Volvo MC110B

The Volvo MC110B is a skid steer loader with an operating weight of 7,480 lb (3,394 kg), a 80.5 hp engine, a rated operating capacity of 2,400 lb (1,088 kg), and a tipping load of 4,804 lb (2,179.06 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,480lb
3,394kg
Engine power
80.5hp
60kW
Net Power
Rated operating capacity
2,400lb
1,088kg
Tipping load
4,804lb † — value reconstructed from related published figures
2,179.06kg
Bucket capacity
0.7yd³
0.6m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Volvo MC110B sits above the median for its class:

  • Operating weight 7,480 lb heavier than 68% (n=334)
  • Engine power 81 hp more powerful than 81% (n=335)
  • Rated operating capacity 2,400 lb higher-rated than 73% (n=288)

◇Scale drawingdrawn to scale · mm

2064C228D3576A2949B
Side elevation
2064C1836E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2244
Engine Model D3.4A
Gross Power 82.6hp 61.6kw
Net Power 80.5hp 60kw
Aspiration Turbocharged
Displacement 201cu in 3.3L

02 Operational Specification

Operational Weight 7480lb 3394kg
Fuel Capacity 23gal 87L
Cooling System Fluid Capacity 4.1gal 15.5L
Engine Oil Fluid Capacity 2.6gal 9.8L
Hydraulic System Fluid Capacity 27.3gal 103.3L
Max Speed 6.2mph 10km/h
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 2400lb 1088kg
Bucket Capacity 0.7yd3 0.6m3

04 Hydraulic Specification

Pump Flow Capacity 20.3gal/min 76.9L/min
Relief Valve Pressure 2700psi 18615.9kPa

05 Dimensions Dimensions

Length With Bucket 11.74ft in 3576mm
Width Over Tires 6.03ft in 1836mm
Ground Clearance 8.98in 228mm
Height To Top Of Cab 6.78ft in 2064mm
Wheelbase 3.63ft in 1106mm
Length W/O Bucket 9.68ft in 2949mm
Clearance At Max Lift And Dump 7.64ft in 2327mm
Reach At Max Lift And Dump 22.29in 566mm
Turning Radius From Center - Machine Rear 57.41in 1458mm
Turning Radius From Center - Inc Bucket 94.14in 2391mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.