Specification sheet Compact Track Loader Ref toro-dingo-tx525-multi-terrain-loader

TORO DINGO TX525

The TORO DINGO TX525 is a compact track loader with an operating weight of 1,904.8 lb (864 kg), a 23.3 hp engine, and a rated operating capacity of 553.37 lb (251 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
1,904.8lb
864kg
Engine power
23.3hp
17.4kW
Gross Power
Rated operating capacity
553.37lb
251kg

Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the TORO DINGO TX525 sits at the compact end of its class:

  • Operating weight 1,900 lb lighter than 99% (n=182)
  • Engine power 23 hp less powerful than 98% (n=167)
  • Rated operating capacity 550 lb lower-rated than 97% (n=156)

Scale drawingdrawn to scale · mm

1171C117D2337A1796B
Side elevation
1171C856E
Front elevation

01 Engine Specification

Engine Make Kubota
Engine Model D902
Gross Power 23.3hp 17.4kw
Power Measured @ 3400rpm
Displacement 55cu in 1L

02 Operational Specification

Operating Weight 1904.8lb 864kg
Engine Oil Capacity 1gal 3.7L
Fuel Capacity 6gal 22.8L

03 Loader Specification

Tip Capacity 1580.8lb 717kg
Operating Load 553.4lb 251kg

04 Hydraulic Specification

Hydraulic Reservoir 10.5gal 39.8L
Pump Flow 16.9gal/min 64L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Ground Clearance 4.6in 116.84mm
Dump Height 3.85ft in 1170.95mm
Dump Height - Maximum 46.1in 1170.94mm
Wheelbase 2.6ft in 792.48mm
Max. Height 90.1in 2288.54mm
Overall Height 3.85ft in 1170.95mm
Overall Width 33.71in 855.98mm
Dump Angle 38degrees
Hinge Pin Height, Maximum Height 65.8in 1671.32mm
Length With Bucket 7.67ft in 2336.81mm
Length With Out Bucket 5.9ft in 1795.79mm

06 Undercarriage Dimensions

Ground Pressure 5psi 34.48kPa
Ground Speed - Front 4.5mph 7.25km/h
Ground Speed - Rear 2mph 3.22km/h
Track Length 569.95ft in 173717.72mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.