Specification sheet Skid Steer Loader Ref thomas-85-skid-steer-loader

Thomas 85

The Thomas 85 is a skid steer loader with an operating weight of 2,983 lb (1,353.07 kg), a 19.8 hp engine, a rated operating capacity of 850 lb (385.56 kg), and a tipping load of 1,800 lb (816.47 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,983lb
1,353.07kg
Engine power
19.8hp
14.8kW
Gross Power
Rated operating capacity
850lb
385.56kg
Tipping load
1,800lb † — value reconstructed from related published figures
816.47kg
Bucket capacity
0.3yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Thomas 85 sits at the compact end of its class:

  • Operating weight 2,980 lb lighter than 95% (n=334)
  • Engine power 20 hp less powerful than 98% (n=335)
  • Rated operating capacity 850 lb lower-rated than 95% (n=288)

◇Scale drawingdrawn to scale · mm

1813C171D2673A2121B
Side elevation
1813C908E
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2334
Engine Model D722B
Gross Power 19.8hp 14.8kw
Power Measured @ 2600rpm
Displacement 43.9cu in 0.8L

02 Operational Specification

Operational Weight 2983lb 1353.1kg
Fuel Capacity 14.6gal 55.3L
Max Speed 5mph 8.1km/h
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Breakout Force 2200lb 998kg
Operating Load Rating 850lb 385.6kg
Bucket Capacity 0.3yd3 0.3m3

04 Hydraulic Specification

Pump Flow Capacity 8gal/min 30.3L/min
Relief Valve Pressure 2100psi 14479kPa

05 Dimensions Dimensions

Length With Bucket 8.77ft in 2673mm
Width Over Tires 2.98ft in 908mm
Ground Clearance 6.75in 171.45mm
Height To Top Of Cab 5.95ft in 1813mm
Wheelbase 2.76ft in 840mm
Length W/O Bucket 6.96ft in 2121mm
Clearance At Max Lift And Dump 5.76ft in 1753mm
Reach At Max Lift And Dump 14.49in 368mm
Turning Radius From Center - Machine Rear 38.08in 967mm
Turning Radius From Center - Inc Bucket 60.2in 1529mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.