Specification sheet Skid Steer Loader Ref thomas-320-skid-steer-loader

Thomas 320

The Thomas 320 is a skid steer loader with an operating weight of 8,175 lb (3,708.12 kg), a 83 hp engine, a rated operating capacity of 2,525 lb (1,145.33 kg), and a tipping load of 5,000 lb (2,267.96 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,175lb
3,708.12kg
Engine power
83hp
61.9kW
Net Power
Rated operating capacity
2,525lb
1,145.33kg
Tipping load
5,000lb † — value reconstructed from related published figures
2,267.96kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Thomas 320 sits above the median for its class:

  • Operating weight 8,180 lb heavier than 84% (n=334)
  • Engine power 83 hp more powerful than 85% (n=335)
  • Rated operating capacity 2,530 lb higher-rated than 82% (n=288)

◇Scale drawingdrawn to scale · mm

2134C488D3708A2985B
Side elevation
2134C1798E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V3300T
Gross Power 87.5hp 65.3kw
Net Power 83hp 61.9kw
Power Measured @ 2750rpm
Displacement 203cu in 3.4L

02 Operational Specification

Operational Weight 8175lb 3708.2kg
Fuel Capacity 28.8gal 109L
Max Speed 12.4mph 19.8km/h
Hydraulic System Fluid Capacity 24gal 90.8L
Tire Size 12.00x16.5
Alternator Supplied Amperage 60amps

03 Loader Specification

Breakout Force 7000lb 3175.2kg
Operating Load Rating 2525lb 1145.4kg

04 Hydraulic Specification

Pump Flow Capacity 21gal/min 79.5L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 12.17ft in 3708mm
Width Over Tires 5.9ft in 1798mm
Ground Clearance 19.2in 487.68mm
Height To Top Of Cab 7.01ft in 2134mm
Wheelbase 4.07ft in 1238mm
Length W/O Bucket 9.8ft in 2985mm
Clearance At Max Lift And Dump 8.07ft in 2459mm
Reach At Max Lift And Dump 21.5in 546mm
Turning Radius From Center - Machine Rear 34.91in 886.5mm
Turning Radius From Center - Inc Bucket 42.01in 1067mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.