Specification sheet Compact Track Loader Ref thomas-320-multi-terrain-loader

Thomas 320

The Thomas 320 is a compact track loader with an operating weight of 10,500 lb (4,762.73 kg), a 83 hp engine, a rated operating capacity of 3,200 lb (1,451.5 kg), and a tipping load of 6,400 lb (2,902.99 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
10,500lb
4,762.73kg
Engine power
83hp
61.9kW
Net Power
Rated operating capacity
3,200lb
1,451.5kg
Tipping load
6,400lb † — value reconstructed from related published figures
2,902.99kg

◆Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Thomas 320 sits above the median for its class:

  • Operating weight 10,500 lb heavier than 77% (n=182)
  • Engine power 83 hp more powerful than 72% (n=167)
  • Rated operating capacity 3,200 lb higher-rated than 70% (n=156)

◇Scale drawingdrawn to scale · mm

2134C488D3708A2985B
Side elevation
2134C1986E
Front elevation

01 Engine Specification

Engine Make 2334
Engine Model V3300T
Gross Power 87.4hp 65.2kw
Net Power 83hp 61.9kw
Power Measured @ 2750rpm
Peak Torque 205lb ft 278Nm
Displacement 203cu in 3.4L

02 Operational Specification

Operating Weight 10500lb 4762.8kg
Fuel Capacity 28.8gal 109L
Hydraulic System Fluid Capacity 24gal 90.8L
Alternator Supplied Amperage 60amps
Max Speed - Low Range 6.8mph 10.9km/h
Max Speed - High Range 12.4mph 19.8km/h

03 Loader Specification

Breakout Force 7000lb 3175.2kg
Operating Load 3200lb 1451.5kg

04 Hydraulic Specification

Pump Flow 21gal/min 79.5L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Width Over Tracks 6.52ft in 1986mm
Height To Top Of Cab 7.01ft in 2134mm
Ground Clearance 19.2in 487.68mm
Clearance At Max Lift And Dump 7.91ft in 2408mm
Reach At Max Lift And Dump 1.93ft in 587mm
Length With Out Bucket 9.8ft in 2985mm
Length With Bucket 12.17ft in 3708mm
Turning Radius From Center - Machine Rear 34.91in 886.5mm
Turning Radius From Center - Inc Bucket 44.81in 1138mm

06 Undercarriage Dimensions

Width Of Track 18in 457mm
Ground Pressure 5.8psi 39.99kPa

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.