Specification sheet Skid Steer Loader Ref thomas-205-skid-steer-loader
Thomas 205
The Thomas 205 is a skid steer loader with an operating weight of 7,200 lb (3,265.87 kg), a 56 hp engine, and a rated operating capacity of 2,100 lb (952.55 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
7,200lb
3,265.87kg
Engine power
56hp
41.76kW
Net Power Rated operating capacity
2,100lb
952.55kg
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Thomas 205 sits above the median for its class:
- Operating weight 7,200 lb heavier than 63% (n=334)
- Engine power 56 hp less powerful than 66% (n=335)
- Rated operating capacity 2,100 lb higher-rated than 62% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2334 | |
|---|---|---|
| Engine Model | V2003MT Turbo | |
| Gross Power | 59.5hp | 44.4kw |
| Net Power | 56hp | 41.8kw |
| Power Measured @ | 2800rpm | |
| Aspiration | turbocharged | |
| Displacement | 122cu in | 2L |
02 Operational Specification
| Operational Weight | 7200lb | 3265.9kg |
|---|---|---|
| Fuel Capacity | 21.2gal | 80L |
| Max Speed | 7.8mph | 12.4km/h |
| Hydraulic System Fluid Capacity | 17.5gal | 66L |
| Tire Size | 12.00x16.5 | |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 40amps |
03 Loader Specification
| Breakout Force | 4900lb | 2222.7kg |
|---|---|---|
| Operating Load Rating | 2100lb | 952.6kg |
04 Hydraulic Specification
| Pump Flow Capacity | 20gal/min | 75.8L/min |
|---|---|---|
| Relief Valve Pressure | 3000psi | 20684.3kPa |
05 Dimensions Dimensions
| Length With Bucket | 11.65ft in | 3550mm |
|---|---|---|
| Width Over Tires | 5.67ft in | 1727mm |
| Ground Clearance | 8.75in | 222mm |
| Height To Top Of Cab | 6.96ft in | 2121mm |
| Wheelbase | 3.51ft in | 1069mm |
| Length W/O Bucket | 9.32ft in | 2838mm |
| Clearance At Max Lift And Dump | 7.92ft in | 2413mm |
| Reach At Max Lift And Dump | 31.5in | 800mm |
| Turning Radius From Center - Machine Rear | 33.76in | 857.5mm |
| Turning Radius From Center - Inc Bucket | 41.8in | 1061.5mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.