Specification sheet Skid Steer Loader Ref thomas-165-skid-steer-loader

Thomas 165

The Thomas 165 is a skid steer loader with an operating weight of 5,698 lb (2,584.57 kg), a 60 hp engine, a rated operating capacity of 1,500 lb (680.39 kg), and a tipping load of 2,992 lb (1,357.15 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,698lb
2,584.57kg
Engine power
60hp
44.8kW
Gross Power
Rated operating capacity
1,500lb
680.39kg
Tipping load
2,992lb † — value reconstructed from related published figures
1,357.15kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Thomas 165 sits below the median for its class:

  • Operating weight 5,700 lb lighter than 74% (n=334)
  • Engine power 60 hp less powerful than 56% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

22799C196D39594A30724B
Side elevation
22799C1195E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2347
Engine Model Turbo A2300
Gross Power 60hp 44.8kw
Displacement 140cu in 2.3L

02 Operational Specification

Operational Weight 5698lb 2584.6kg
Fuel Capacity 20gal 75.8L
Max Speed 7.1mph 11.5km/h
Hydraulic System Fluid Capacity 17.2gal 65.2L
Operating Speed 7.1mph 11.5km/h
Operating Voltage 12V
Alternator Supplied Amperage 70amps

03 Loader Specification

Breakout Force 4150lb 1882.5kg
Operating Load Rating 1500lb 680.4kg

04 Hydraulic Specification

Pump Type Hydrostatic
Pump Flow Capacity 20gal/min 75.8L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 129.9ft in 39593.52mm
Width Over Tires 3.92ft in 1194.82mm
Ground Clearance 7.7in 195.58mm
Height To Top Of Cab 74.8ft in 22799.04mm
Wheelbase 41.4ft in 12618.72mm
Length W/O Bucket 100.8ft in 30723.84mm
Clearance At Max Lift And Dump 6.92ft in 2109.22mm
Reach At Max Lift And Dump 27.2in 690.88mm
Turning Radius From Center - Machine Rear 49.6in 1259.84mm
Turning Radius From Center - Inc Bucket 97.4in 2473.96mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.