Specification sheet Skid Steer Loader Ref thomas-153-skid-steer-loader

Thomas 153

The Thomas 153 is a skid steer loader with an operating weight of 5,520 lb (2,503.83 kg), a 50 hp engine, a rated operating capacity of 1,500 lb (680.39 kg), and a tipping load of 3,000 lb (1,360.78 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,520lb
2,503.83kg
Engine power
50hp
37.3kW
Gross Power
Rated operating capacity
1,500lb
680.39kg
Tipping load
3,000lb † — value reconstructed from related published figures
1,360.78kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Thomas 153 sits below the median for its class:

  • Operating weight 5,520 lb lighter than 78% (n=334)
  • Engine power 50 hp less powerful than 72% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

1867C191D3246A2652B
Side elevation
1867C1461E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2203E
Gross Power 50hp 37.3kw
Power Measured @ 2800rpm
Displacement 134cu in 2.2L

02 Operational Specification

Operational Weight 5520lb 2503.9kg
Fuel Capacity 16.8gal 63.6L
Hydraulic System Fluid Capacity 16.6gal 62.9L
Operating Speed 6mph 9.7km/h
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Breakout Force 4150lb 1882.5kg
Operating Load Rating 1500lb 680.4kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Type Hydroststic
Pump Flow Capacity 8gal/min 30.3L/min
Relief Valve Pressure 2400psi 16547.5kPa

05 Dimensions Dimensions

Length With Bucket 10.65ft in 3246mm
Width Over Tires 4.8ft in 1461mm
Ground Clearance 7.5in 190.5mm
Height To Top Of Cab 6.13ft in 1867mm
Wheelbase 2.92ft in 889mm
Length W/O Bucket 8.71ft in 2652mm
Clearance At Max Lift And Dump 7.49ft in 2281mm
Reach At Max Lift And Dump 28in 711mm
Turning Radius From Center - Machine Rear 48in 1219mm
Turning Radius From Center - Inc Bucket 72.6in 1844mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.