Specification sheet Skid Steer Loader Ref thomas-105-skid-steer-loader

Thomas 105

The Thomas 105 is a skid steer loader with an operating weight of 3,700 lb (1,678.3 kg), a 33 hp engine, a rated operating capacity of 1,000 lb (453.6 kg), and a tipping load of 2,000 lb (907.19 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
3,700lb
1,678.3kg
Engine power
33hp
24.7kW
Gross Power
Rated operating capacity
1,000lb
453.6kg
Tipping load
2,000lb † — value reconstructed from related published figures
907.19kg
Bucket capacity
0.4yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Thomas 105 sits at the compact end of its class:

  • Operating weight 3,700 lb lighter than 93% (n=334)
  • Engine power 33 hp less powerful than 93% (n=335)
  • Rated operating capacity 1,000 lb lower-rated than 92% (n=288)

◇Scale drawingdrawn to scale · mm

1803C178D2921A2311B
Side elevation
1803C1289E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V1305B
Gross Power 33hp 24.7kw
Power Measured @ 3000rpm
Displacement 81.5cu in 1.4L

02 Operational Specification

Operational Weight 3700lb 1678.3kg
Fuel Capacity 11.3gal 42.8L
Hydraulic System Fluid Capacity 9gal 34.1L
Operating Voltage 12V
Alternator Supplied Amperage 60amps

03 Loader Specification

Breakout Force 1750lb 793.8kg
Operating Load Rating 1000lb 453.6kg
Bucket Capacity 0.4yd3 0.3m3

04 Hydraulic Specification

Pump Type Hydrostatic
Pump Flow Capacity 8.7gal/min 33L/min
Relief Valve Pressure 2150psi 14823.8kPa

05 Dimensions Dimensions

Length With Bucket 9.59ft in 2921mm
Width Over Tires 4.23ft in 1289mm
Ground Clearance 7.01in 178mm
Height To Top Of Cab 5.92ft in 1803mm
Wheelbase 2.77ft in 843mm
Length W/O Bucket 7.59ft in 2311mm
Clearance At Max Lift And Dump 6.84ft in 2083mm
Reach At Max Lift And Dump 23.51in 597mm
Turning Radius From Center - Machine Rear 54.02in 1372mm
Turning Radius From Center - Inc Bucket 67.37in 1711mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.