Specification sheet Compact Track Loader Ref terex-pt70-multi-terrain-loader

Terex PT70

The Terex PT70 is a compact track loader with an operating weight of 7,890 lb (3,578.85 kg), a 71 hp engine, a rated operating capacity of 2,750 lb (1,247.38 kg), and a tipping load of 5,500 lb (2,494.76 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,890lb
3,578.85kg
Engine power
71hp
53kW
Gross Power
Rated operating capacity
2,750lb
1,247.38kg

Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Terex PT70 sits below the median for its class:

  • Operating weight 7,890 lb lighter than 73% (n=182)
  • Engine power 71 hp less powerful than 60% (n=167)
  • Rated operating capacity 2,750 lb higher-rated than 51% (n=156)

Scale drawingdrawn to scale · mm

2210C381D3632A2845B1803E
Side elevation
2210C1676F
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 804C-33T
Gross Power 71hp 53kw
Power Measured @ 2800rpm
Peak Torque 178.5lb ft 242.1Nm
Displacement 202cu in 3.4L
Aspiration Turbocharged

02 Operational Specification

Operating Weight 7890lb 3578.9kg
Cooling System Fluid Capacity 3gal 11.4L
Fuel Capacity 18gal 68.2L
Engine Oil Capacity 2.3gal 8.5L
Hydraulic System Fluid Capacity 21gal 79.5L
Operating Voltage 12V
Alternator Supplied Amperage 90amps
Max Speed - Low Range 7mph 11.3km/h

03 Loader Specification

Operating Load 2750lb 1247.4kg

04 Hydraulic Specification

Pump Flow 20gal/min 75.8L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Width Over Tracks 5.5ft in 1676mm
Height To Top Of Cab 7.26ft in 2210mm
Ground Clearance 15in 381mm
Clearance At Max Lift And Dump 8.26ft in 2515mm
Length With Out Bucket 9.34ft in 2845mm
Length With Bucket 11.92ft in 3632mm

06 Undercarriage Dimensions

Length Of Track On Ground 5.92ft in 1803mm
Ground Contact Area 2130in2 1.38m2
Ground Pressure 3.7psi 25.52kPa
Number Of Track Rollers Per Side 14
Width Of Track 15in 381mm

Data notes

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.