Specification sheet Compact Track Loader Ref terex-pt60-multi-terrain-loader

Terex PT60

The Terex PT60 is a compact track loader with an operating weight of 6,350 lb (2,880.32 kg), a 60 hp engine, a rated operating capacity of 1,900 lb (861.83 kg), and a tipping load of 3,800 lb (1,723.65 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,350lb
2,880.32kg
Engine power
60hp
44.8kW
Gross Power
Rated operating capacity
1,900lb
861.83kg

Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Terex PT60 sits at the compact end of its class:

  • Operating weight 6,350 lb lighter than 87% (n=182)
  • Engine power 60 hp less powerful than 80% (n=167)
  • Rated operating capacity 1,900 lb lower-rated than 83% (n=156)

Scale drawingdrawn to scale · mm

1956C305D3251A2540B1499E
Side elevation
1956C1676F
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 404D-22T
Gross Power 60hp 44.8kw
Power Measured @ 2800rpm
Peak Torque 140lb ft 189.9Nm
Displacement 134cu in 2.2L
Aspiration Turbocharged

02 Operational Specification

Operating Weight 6350lb 2880.4kg
Cooling System Fluid Capacity 2gal 7.6L
Fuel Capacity 13.7gal 51.9L
Engine Oil Capacity 2.9gal 10.6L
Hydraulic System Fluid Capacity 8gal 30.3L
Operating Voltage 12V
Alternator Supplied Amperage 65amps
Max Speed - Low Range 6mph 9.7km/h
Max Speed - High Range 11mph 17.8km/h

03 Loader Specification

Operating Load 1900lb 861.9kg

04 Hydraulic Specification

Pump Flow 16.3gal/min 61.8L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Width Over Tracks 5.5ft in 1676mm
Height To Top Of Cab 6.42ft in 1956mm
Ground Clearance 12.01in 305mm
Clearance At Max Lift And Dump 7.59ft in 2311mm
Length With Out Bucket 8.34ft in 2540mm
Length With Bucket 10.67ft in 3251mm

06 Undercarriage Dimensions

Length Of Track On Ground 4.92ft in 1499mm
Ground Contact Area 1770in2 1.15m2
Ground Pressure 3.6psi 24.83kPa
Number Of Track Rollers Per Side 12
Width Of Track 15in 381mm

Data notes

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.