Specification sheet Compact Track Loader Ref terex-pt30-multi-terrain-loader

Terex PT30

The Terex PT30 is a compact track loader with an operating weight of 3,600 lb (1,632.94 kg), a 33.7 hp engine, a rated operating capacity of 950 lb (430.92 kg), and a tipping load of 1,900 lb (861.83 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
3,600lb
1,632.94kg
Engine power
33.7hp
25.2kW
Gross Power
Rated operating capacity
950lb
430.92kg
Tipping load
1,900lb † — value reconstructed from related published figures
861.83kg

◆Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Terex PT30 sits at the compact end of its class:

  • Operating weight 3,600 lb lighter than 93% (n=182)
  • Engine power 34 hp less powerful than 94% (n=167)
  • Rated operating capacity 950 lb lower-rated than 93% (n=156)

◇Scale drawingdrawn to scale · mm

1840C254D2896A2298B1397E
Side elevation
1840C1219F
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2351
Engine Model 403D-15
Gross Power 33.7hp 25.2kw
Power Measured @ 2800rpm
Peak Torque 64.3lb ft 87.2Nm
Displacement 92cu in 1.6L
Aspiration Natural

02 Operational Specification

Operating Weight 3600lb 1633kg
Cooling System Fluid Capacity 1.5gal 5.7L
Fuel Capacity 10gal 37.9L
Engine Oil Capacity 1.1gal 3.8L
Hydraulic System Fluid Capacity 8gal 30.3L
Operating Voltage 12V
Alternator Supplied Amperage 65amps
Max Speed - Low Range 6mph 9.7km/h

03 Loader Specification

Operating Load 950lb 431kg

04 Hydraulic Specification

Pump Flow 10gal/min 37.9L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Width Over Tracks 4ft in 1219mm
Height To Top Of Cab 6.04ft in 1840mm
Ground Clearance 10in 254mm
Clearance At Max Lift And Dump 6.44ft in 1962mm
Length With Out Bucket 7.54ft in 2298.2mm
Length With Bucket 9.51ft in 2896mm

06 Undercarriage Dimensions

Length Of Track On Ground 4.59ft in 1397mm
Ground Contact Area 1183in2 0.77m2
Ground Pressure 3psi 20.69kPa
Number Of Track Rollers Per Side 12
Width Of Track 11in 279.4mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.