Specification sheet Skid Steer Loader Ref sunward-swl3210-skid-steer-loader

Sunward SWL3210

The Sunward SWL3210 is a skid steer loader with an operating weight of 7,165.03 lb (3,250 kg), a 73.63 hp engine, a rated operating capacity of 2,094.4 lb (950 kg), and a tipping load of 4,188.8 lb (1,900.01 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,165.03lb
3,250kg
Engine power
73.63hp
54.9kW
Net Power
Rated operating capacity
2,094.4lb
950kg
Tipping load
4,188.8lb † — value reconstructed from related published figures
1,900.01kg
Bucket capacity
0.7yd³
0.6m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Sunward SWL3210 sits above the median for its class:

  • Operating weight 7,170 lb heavier than 62% (n=334)
  • Engine power 74 hp more powerful than 67% (n=335)
  • Rated operating capacity 2,090 lb higher-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

2100C205D3590A2750B
Side elevation
2100C1880E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V3300DI
Net Power 73.7hp 54.9kw
Power Measured @ 2600rpm

02 Operational Specification

Operational Weight 7165.1lb 3250kg
Fuel Capacity 22.5gal 85L
Cooling System Fluid Capacity 2.3gal 8.5L
Engine Oil Fluid Capacity 3.5gal 13.2L
Max Speed 7.9mph 12.6km/h
Hydraulic System Fluid Capacity 17.2gal 65L
Chain Box Fluid Capacity - Each Side 8gal 30L
Tire Size 12-16.5

03 Loader Specification

Breakout Force 5357.3lb 2430kg
Operating Load Rating 2094.4lb 950kg
Bucket Capacity 0.7yd3 0.6m3

04 Hydraulic Specification

Pump Type Gear
Pump Flow Capacity 33gal/min 124.8L/min
Relief Valve Pressure 3626psi 25000kPa

05 Dimensions Dimensions

Length With Bucket 11.78ft in 3590mm
Width Over Tires 6.17ft in 1880mm
Ground Clearance 8.08in 205mm
Height To Top Of Cab 6.89ft in 2100mm
Wheelbase 3.67ft in 1116mm
Length W/O Bucket 9.03ft in 2750mm
Clearance At Max Lift And Dump 7.86ft in 2395mm
Reach At Max Lift And Dump 24.61in 625mm
Turning Radius From Center - Machine Rear 66.93in 1700mm
Turning Radius From Center - Inc Bucket 85.83in 2180mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.