Specification sheet Skid Steer Loader Ref sunward-swl2810-skid-steer-loader

Sunward SWL2810

The Sunward SWL2810 is a skid steer loader with an operating weight of 6,128.86 lb (2,780 kg), a 53.51 hp engine, a rated operating capacity of 1,598.36 lb (725 kg), and a tipping load of 3,196.8 lb (1,450.05 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,128.86lb
2,780kg
Engine power
53.51hp
39.9kW
Net Power
Rated operating capacity
1,598.36lb
725kg
Tipping load
3,196.8lb † — value reconstructed from related published figures
1,450.05kg
Bucket capacity
0.6yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Sunward SWL2810 sits below the median for its class:

  • Operating weight 6,130 lb lighter than 67% (n=334)
  • Engine power 54 hp less powerful than 69% (n=335)
  • Rated operating capacity 1,600 lb lower-rated than 67% (n=288)

◇Scale drawingdrawn to scale · mm

2018C190D3261A2475B
Side elevation
2018C1600E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV84T
Net Power 53.6hp 39.9kw
Power Measured @ 2800rpm

02 Operational Specification

Operational Weight 6128.9lb 2780kg
Fuel Capacity 18.5gal 70L
Cooling System Fluid Capacity 2.1gal 7.7L
Engine Oil Fluid Capacity 2gal 7.4L
Max Speed 8.5mph 13.6km/h
Hydraulic System Fluid Capacity 13.3gal 50L
Chain Box Fluid Capacity - Each Side 8gal 30L
Tire Size 10-16.5

03 Loader Specification

Breakout Force 4188.8lb 1900kg
Operating Load Rating 1598.4lb 725kg
Bucket Capacity 0.6yd3 0.4m3

04 Hydraulic Specification

Pump Type Gear
Pump Flow Capacity 27.4gal/min 103.6L/min
Relief Valve Pressure 3625psi 24993.5kPa

05 Dimensions Dimensions

Length With Bucket 10.7ft in 3261mm
Width Over Tires 5.25ft in 1600mm
Ground Clearance 7.49in 190mm
Height To Top Of Cab 6.63ft in 2018mm
Wheelbase 3.24ft in 987mm
Length W/O Bucket 8.13ft in 2475mm
Clearance At Max Lift And Dump 7.62ft in 2320mm
Reach At Max Lift And Dump 18.71in 475mm
Turning Radius From Center - Machine Rear 60.4in 1534mm
Turning Radius From Center - Inc Bucket 76.93in 1954mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.