Specification sheet Wheel Loader Ref schaffer-9100z-wheel-loader
Schaffer 9100Z
The Schaffer 9100Z is a wheel loader with an operating weight of 13,227.74 lb (6,000 kg), a 102 hp engine, and a 1.31 yd³ (1 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
13,227.74lb
6,000kg
Engine power
102hp
76.07kW
Gross Power Bucket capacity
1.31yd³
1m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Schaffer 9100Z sits in the middle of its class:
- Operating weight 13,230 lb heavier than 56% (n=374)
- Engine power 102 hp more powerful than 82% (n=367)
- Bucket capacity 1.3 yd³ smaller-bucket than 56% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2349 | |
|---|---|---|
| Engine Model | BF4M2012 | |
| Gross Power | 102hp | 76.1kw |
02 Operational Specification
| Operating Weight | 13227.8lb | 6000kg |
|---|---|---|
| Fuel Capacity | 25.1gal | 95L |
| Hydraulic System Fluid Capacity | 27.8gal | 105L |
| Static Tipping Weight | 9700.4lb | 4400kg |
| Tire Size | 405x70-20 |
03 Transmission Specification
| Transmission Type | hydrostatic | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 12.5mph | 20km/h |
| Max Speed - Reverse | 12.5mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 7000psi | 48263.3kPa |
|---|---|---|
| Pump Flow Capacity | 52.4gal/min | 198L/min |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.86ft in | 2700mm |
|---|---|---|
| Bucket Capacity - Heaped | 1.31yd3 | 1m3 |
| Breakout Force | 6069.85lb | 27kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 14.93ft in | 4550mm |
|---|---|---|
| Width Over Tires | 6.73ft in | 2050mm |
| Height To Top Of Cab | 8.08ft in | 2460mm |
| Wheelbase | 7.12ft in | 2170mm |
| Hinge Pin - Max Height | 11.16ft in | 3400mm |
| Reach At Max Lift And Dump | 1.53ft in | 465mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.