Specification sheet Wheel Loader Ref schaffer-5058zs-wheel-loader
Schaffer 5058ZS
The Schaffer 5058ZS is a wheel loader with an operating weight of 11,023.12 lb (5,000 kg), a 70 hp engine, and a 0.99 yd³ (0.75 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
11,023.12lb
5,000kg
Engine power
70hp
52.2kW
Gross Power Bucket capacity
0.99yd³
0.75m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Schaffer 5058ZS sits below the median for its class:
- Operating weight 11,020 lb lighter than 65% (n=374)
- Engine power 70 hp less powerful than 52% (n=367)
- Bucket capacity 1 yd³ smaller-bucket than 80% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2334 | |
|---|---|---|
| Engine Model | V3300E | |
| Gross Power | 70hp | 52.2kw |
02 Operational Specification
| Operating Weight | 11023.2lb | 5000kg |
|---|---|---|
| Fuel Capacity | 15.9gal | 60L |
| Hydraulic System Fluid Capacity | 15.9gal | 60L |
| Static Tipping Weight | 6834.4lb | 3100kg |
| Tire Size | 365X70-18 |
03 Transmission Specification
| Transmission Type | hydrostatic | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 12.5mph | 20km/h |
| Max Speed - Reverse | 12.5mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 5000psi | 34473.8kPa |
|---|---|---|
| Pump Flow Capacity | 37gal/min | 140L/min |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.86ft in | 2700mm |
|---|---|---|
| Bucket Capacity - Heaped | 0.99yd3 | 0.75m3 |
| Breakout Force | 6069.85lb | 27kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 15.59ft in | 4750mm |
|---|---|---|
| Width Over Tires | 5.25ft in | 1600mm |
| Height To Top Of Cab | 7.71ft in | 2350mm |
| Wheelbase | 6.34ft in | 1930mm |
| Hinge Pin - Max Height | 11.16ft in | 3400mm |
| Reach At Max Lift And Dump | 1.97ft in | 600mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.