Specification sheet Wheel Loader Ref schaffer-5050z-wheel-loader
Schaffer 5050Z
The Schaffer 5050Z is a wheel loader with an operating weight of 9,259.42 lb (4,200 kg), a 50 hp engine, and a 0.66 yd³ (0.5 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
9,259.42lb
4,200kg
Engine power
50hp
37.29kW
Gross Power Bucket capacity
0.66yd³
0.5m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Schaffer 5050Z sits below the median for its class:
- Operating weight 9,260 lb lighter than 80% (n=374)
- Engine power 50 hp less powerful than 80% (n=367)
- Bucket capacity 0.7 yd³ smaller-bucket than 93% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2334 | |
|---|---|---|
| Engine Model | V2203 | |
| Gross Power | 50hp | 37.3kw |
02 Operational Specification
| Operating Weight | 9259.5lb | 4200kg |
|---|---|---|
| Fuel Capacity | 12.7gal | 48L |
| Hydraulic System Fluid Capacity | 13.3gal | 50L |
| Static Tipping Weight | 5070.7lb | 2300kg |
| Tire Size | 15X55-17 |
03 Transmission Specification
| Transmission Type | hydrostatic | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 12.5mph | 20km/h |
| Max Speed - Reverse | 12.5mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 5000psi | 34473.8kPa |
|---|---|---|
| Pump Flow Capacity | 33.3gal/min | 126L/min |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 5.58ft in | 1700mm |
|---|---|---|
| Bucket Capacity - Heaped | 0.66yd3 | 0.5m3 |
| Breakout Force | 6069.85lb | 27kN |
06 Dimensions Dimensions
| Length With Bucket On Ground | 15.59ft in | 4750mm |
|---|---|---|
| Width Over Tires | 5.25ft in | 1600mm |
| Height To Top Of Cab | 7.22ft in | 2200mm |
| Wheelbase | 5.65ft in | 1720mm |
| Hinge Pin - Max Height | 10.83ft in | 3300mm |
| Reach At Max Lift And Dump | 1.81ft in | 550mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.