Specification sheet Skid Steer Loader Ref scat-trak-2000dx-skid-steer-loader

Scat Trak 2000DX

The Scat Trak 2000DX is a skid steer loader with an operating weight of 7,045 lb (3,195.56 kg), a 86 hp engine, a rated operating capacity of 2,000 lb (907.19 kg), and a tipping load of 4,000 lb (1,814.37 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,045lb
3,195.56kg
Engine power
86hp
64.2kW
Gross Power
Rated operating capacity
2,000lb
907.19kg
Tipping load
4,000lb † — value reconstructed from related published figures
1,814.37kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Scat Trak 2000DX sits in the middle of its class:

  • Operating weight 7,050 lb heavier than 59% (n=334)
  • Engine power 86 hp more powerful than 93% (n=335)
  • Rated operating capacity 2,000 lb higher-rated than 56% (n=288)

◇Scale drawingdrawn to scale · mm

2045C188D3500A2769B
Side elevation
2045C1824E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 1004.42
Gross Power 86hp 64.2kw
Power Measured @ 2400rpm
Displacement 258cu in 4.3L

02 Operational Specification

Operational Weight 7045lb 3195.6kg
Fuel Capacity 21.6gal 81.7L
Hydraulic System Fluid Capacity 17.1gal 64.7L
Max Speed 6.3mph 10.1km/h
Tire Size 12.00x16.5
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 2000lb 907.2kg

04 Hydraulic Specification

Pump Flow Capacity 33gal/min 124.9L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 11.49ft in 3500mm
Width Over Tires 5.99ft in 1824mm
Ground Clearance 7.41in 188mm
Height To Top Of Cab 6.71ft in 2045mm
Wheelbase 3.51ft in 1067mm
Length W/O Bucket 9.09ft in 2769mm
Clearance At Max Lift And Dump 7.85ft in 2390mm
Reach At Max Lift And Dump 24.22in 615mm
Turning Radius From Center - Machine Rear 64.02in 1626mm
Turning Radius From Center - Inc Bucket 50.99in 1295mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.