Specification sheet Skid Steer Loader Ref scat-trak-1750d-skid-steer-loader

Scat Trak 1750D

The Scat Trak 1750D is a skid steer loader with an operating weight of 6,980 lb (3,166.08 kg), a 86 hp engine, a rated operating capacity of 1,875 lb (850.49 kg), and a tipping load of 3,750 lb (1,700.97 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,980lb
3,166.08kg
Engine power
86hp
64.2kW
Gross Power
Rated operating capacity
1,875lb
850.49kg
Tipping load
3,750lb † — value reconstructed from related published figures
1,700.97kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Scat Trak 1750D sits in the middle of its class:

  • Operating weight 6,980 lb heavier than 55% (n=334)
  • Engine power 86 hp more powerful than 93% (n=335)
  • Rated operating capacity 1,880 lb lower-rated than 52% (n=288)

◇Scale drawingdrawn to scale · mm

2032C180D3500A2769B
Side elevation
2032C1824E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 1004.42
Gross Power 86hp 64.2kw
Power Measured @ 2400rpm
Displacement 258cu in 4.3L

02 Operational Specification

Operational Weight 6980lb 3166.1kg
Fuel Capacity 21.6gal 81.7L
Max Speed 6.1mph 9.7km/h
Hydraulic System Fluid Capacity 17.1gal 64.7L
Tire Size 12.00x16.5
Operating Voltage 12V
Alternator Supplied Amperage 55amps

03 Loader Specification

Operating Load Rating 1875lb 850.5kg

04 Hydraulic Specification

Pump Flow Capacity 19.1gal/min 72L/min

05 Dimensions Dimensions

Length With Bucket 11.49ft in 3500mm
Width Over Tires 5.99ft in 1824mm
Ground Clearance 7.09in 180mm
Height To Top Of Cab 6.67ft in 2032mm
Wheelbase 3.34ft in 1016mm
Length W/O Bucket 9.09ft in 2769mm
Clearance At Max Lift And Dump 7.84ft in 2388mm
Reach At Max Lift And Dump 24.22in 615mm
Turning Radius From Center - Machine Rear 64.02in 1626mm
Turning Radius From Center - Inc Bucket 50.52in 1283mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.