Specification sheet Skid Steer Loader Ref scat-trak-1500dx-skid-steer-loader

Scat Trak 1500DX

The Scat Trak 1500DX is a skid steer loader with an operating weight of 5,957 lb (2,702.05 kg), a 60 hp engine, a rated operating capacity of 1,500 lb (680.39 kg), and a tipping load of 3,000 lb (1,360.78 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,957lb
2,702.05kg
Engine power
60hp
44.8kW
Gross Power
Rated operating capacity
1,500lb
680.39kg
Tipping load
3,000lb † — value reconstructed from related published figures
1,360.78kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Scat Trak 1500DX sits below the median for its class:

  • Operating weight 5,960 lb lighter than 69% (n=334)
  • Engine power 60 hp less powerful than 56% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

1981C203D3289A2598B
Side elevation
1981C1651E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2003-TE
Gross Power 60hp 44.8kw
Power Measured @ 2800rpm
Aspiration turbocharged
Displacement 122cu in 2L

02 Operational Specification

Operational Weight 5957lb 2702.1kg
Fuel Capacity 17.4gal 65.5L
Hydraulic System Fluid Capacity 10gal 37.8L
Max Speed 6.9mph 11.1km/h
Tire Size 10.00x16.5
Operating Voltage 12V

03 Loader Specification

Operating Load Rating 1500lb 680.4kg

04 Hydraulic Specification

Pump Flow Capacity 31gal/min 117L/min
Relief Valve Pressure 2500psi 17236.9kPa

05 Dimensions Dimensions

Length With Bucket 10.8ft in 3289mm
Width Over Tires 5.42ft in 1651mm
Ground Clearance 8in 203mm
Height To Top Of Cab 6.5ft in 1981mm
Wheelbase 3.34ft in 1016mm
Length W/O Bucket 8.53ft in 2598mm
Clearance At Max Lift And Dump 7.49ft in 2281mm
Reach At Max Lift And Dump 24.02in 610mm
Turning Radius From Center - Machine Rear 60.52in 1537mm
Turning Radius From Center - Inc Bucket 77.01in 1956mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.