Specification sheet Skid Steer Loader Ref scat-trak-1300d-skid-steer-loader

Scat Trak 1300D

The Scat Trak 1300D is a skid steer loader with an operating weight of 5,404 lb (2,451.22 kg), a 49.5 hp engine, a rated operating capacity of 1,350 lb (612.35 kg), and a tipping load of 2,700 lb (1,224.7 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,404lb
2,451.22kg
Engine power
49.5hp
37kW
Gross Power
Rated operating capacity
1,350lb
612.35kg
Tipping load
2,700lb † — value reconstructed from related published figures
1,224.7kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Scat Trak 1300D sits below the median for its class:

  • Operating weight 5,400 lb lighter than 81% (n=334)
  • Engine power 50 hp less powerful than 73% (n=335)
  • Rated operating capacity 1,350 lb lower-rated than 83% (n=288)

◇Scale drawingdrawn to scale · mm

1974C193D3289A2597B
Side elevation
1974C1511E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2203-E
Gross Power 49.5hp 37kw
Power Measured @ 2800rpm
Displacement 134.3cu in 2.2L

02 Operational Specification

Operational Weight 5404lb 2451.3kg
Fuel Capacity 17.4gal 65.5L
Hydraulic System Fluid Capacity 10gal 37.8L
Max Speed 6.4mph 10.3km/h
Tire Size 10x16.5
Operating Voltage 12V

03 Loader Specification

Operating Load Rating 1350lb 612.4kg

04 Hydraulic Specification

Pump Flow Capacity 16.4gal/min 62L/min

05 Dimensions Dimensions

Length With Bucket 10.8ft in 3289mm
Width Over Tires 4.96ft in 1511mm
Ground Clearance 7.6in 193mm
Height To Top Of Cab 6.48ft in 1974mm
Wheelbase 3.05ft in 927mm
Length W/O Bucket 8.53ft in 2597mm
Clearance At Max Lift And Dump 7.42ft in 2261mm
Reach At Max Lift And Dump 24.02in 610mm
Turning Radius From Center - Machine Rear 62.21in 1580mm
Turning Radius From Center - Inc Bucket 74.02in 1880mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.