Specification sheet Skid Steer Loader Ref new-holland-ls140-skid-steer-loader

New Holland LS140

The New Holland LS140 is a skid steer loader with an operating weight of 4,396.02 lb (1,994 kg), a 30 hp engine, a rated operating capacity of 1,250.03 lb (567 kg), and a tipping load of 2,500.1 lb (1,134.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,396.02lb
1,994kg
Engine power
30hp
22.38kW
Net Power
Rated operating capacity
1,250.03lb
567kg
Tipping load
2,500.1lb † — value reconstructed from related published figures
1,134.03kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland LS140 sits at the compact end of its class:

  • Operating weight 4,400 lb lighter than 90% (n=334)
  • Engine power 30 hp less powerful than 94% (n=335)
  • Rated operating capacity 1,250 lb lower-rated than 89% (n=288)

◇Scale drawingdrawn to scale · mm

1860B210C3040A
Side elevation
1860B1250D
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2249
Engine Model N843
Net Power 30hp 22.4kw
Power Measured @ 2900rpm
Displacement 91.6cu in 1.5L

02 Operational Specification

Operational Weight 4396.1lb 1994kg
Fuel Capacity 8.8gal 33.1L
Cooling System Fluid Capacity 2.5gal 9.3L
Engine Oil Fluid Capacity 1.5gal 5.5L
Max Speed 6.8mph 10.8km/h
Hydraulic System Fluid Capacity 5gal 18.9L
Chain Box Fluid Capacity - Each Side 1.6gal 5.7L
Tire Size 10x16.5
Operating Voltage 12V
Alternator Supplied Amperage 40amps

03 Loader Specification

Breakout Force 3404lb 1544kg
Operating Load Rating 1250.1lb 567kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Type New Holland double acting
Pump Flow Capacity 10.8gal/min 40.9L/min
Relief Valve Pressure 2600psi 17926.4kPa

05 Dimensions Dimensions

Length With Bucket 9.98ft in 3040mm
Width Over Tires 4.11ft in 1250mm
Ground Clearance 8.27in 210mm
Height To Top Of Cab 6.11ft in 1860mm
Wheelbase 3.12ft in 950mm
Clearance At Max Lift And Dump 7.26ft in 2210mm
Reach At Max Lift And Dump 25.2in 640mm
Turning Radius From Center - Machine Rear 56.3in 1430mm
Turning Radius From Center - Inc Bucket 70.48in 1790mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.