Specification sheet Skid Steer Loader Ref new-holland-ls125-skid-steer-loader

New Holland LS125

The New Holland LS125 is a skid steer loader with an operating weight of 2,184.79 lb (991 kg), a 16.5 hp engine, a rated operating capacity of 698.87 lb (317 kg), and a tipping load of 1,400 lb (635.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,184.79lb
991kg
Engine power
16.5hp
12.4kW
Gross Power
Rated operating capacity
698.87lb
317kg
Tipping load
1,400lb † — value reconstructed from related published figures
635.03kg
Bucket capacity
0.2yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland LS125 sits at the compact end of its class:

  • Operating weight 2,180 lb lighter than 99% (n=334)
  • Engine power 17 hp less powerful than 100% (n=335)
  • Rated operating capacity 700 lb lower-rated than 98% (n=288)

◇Scale drawingdrawn to scale · mm

1760B170C2420A
Side elevation
1760B890D
Front elevation

01 Engine Specification

Engine Make 2249
Engine Model NH673
Gross Power 16.5hp 12.4kw
Displacement 41.2cu in 0.7L

02 Operational Specification

Operational Weight 2184.8lb 991kg
Fuel Capacity 6gal 22.7L
Cooling System Fluid Capacity 1.2gal 4.4L
Engine Oil Fluid Capacity 0.9gal 3.1L
Hydraulic System Fluid Capacity 9.1gal 34.1L
Max Speed 5.8mph 9.3km/h
Tire Size 12x16.5
Operating Voltage 12V
Alternator Supplied Amperage 20amps

03 Loader Specification

Breakout Force 1137.6lb 516kg
Operating Load Rating 698.9lb 317kg
Bucket Capacity 0.2yd3 0.2m3

04 Hydraulic Specification

Pump Type New Holland double acting
Pump Flow Capacity 8gal/min 30.2L/min
Relief Valve Pressure 1600psi 11031.7kPa

05 Dimensions Dimensions

Length With Bucket 7.94ft in 2420mm
Width Over Tires 2.92ft in 890mm
Ground Clearance 6.7in 170mm
Height To Top Of Cab 5.78ft in 1760mm
Wheelbase 2.66ft in 810mm
Clearance At Max Lift And Dump 5.25ft in 1600mm
Reach At Max Lift And Dump 21.26in 540mm
Turning Radius From Center - Machine Rear 7.09in 180mm
Turning Radius From Center - Inc Bucket 57.88in 1470mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.