Specification sheet Skid Steer Loader Ref new-holland-l213-skid-steer-loader

New Holland L213

The New Holland L213 is a skid steer loader with an operating weight of 5,070.7 lb (2,300 kg), and a tipping load of 2,599.3 lb (1,179 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,070.7lb
2,300kg
Tipping load
2,599.3lb
1,179kg

Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland L213 sits at the compact end of its class:

  • Operating weight 5,070 lb lighter than 86% (n=334)

Not positioned on engine power, rated operating capacity — withheld or unpublished for this machine.

01 Engine Specification

Air Intake Naturally aspirated
Fuel Injection Indirect
Horsepower Per Sae J1349 Net 46hp 34.4kw
Horsepower Per Sae J1349 Gross 49hp 36.6kw
Engine Model N844L
Rated Speed 2800rpm
Peak Torque 105.5lb ft 143Nm
Displacement 135.3cu in 2.3L
Bore 3.4in 84mm
Stroke 4in 100mm

02 Capacities Specification

Engine Oil With Filter 1.9gal 7.1L
Chain Tanks 1.7gal 6.3L
Fuel Tank 16gal 60.5L

03 Performance Specification

Tipping Load 2599.3lb 1179kg
Operating Weight 5070.7lb 2300kg
Breakout Force, Bucket Cylinder 4181.5lb 18.6kN
Breakout Force, Lift Cylinder 2855.1lb 12.7kN
Rated Operating Load, 50% Tip 1300.8lb 590kg

04 Power Train Specification

Travel Speed, Low Range 7.4mph 12km/h

05 Weights Specification

Operating Weight 5070.7lb 2300kg
Shipping 4762lb 2160kg

06 Hydraulic System Specification

Standard Pump Flow 17.5gal/min 66.3L/min
Relief Valve Pressure 3046psi 21001.5kPa

07 Dimensions Dimensions

Ground Clearance 7.01in 178mm
Wheelbase 3.09ft in 941mm
Bucket Hinge Pin 112.01in 2845mm
Dump Angle 40 degrees
Angle Of Departure 22degrees
Rollback, Bucket At Full Height 95degrees
Rollback, Bucket On Ground 26degrees
Top Of Rops 75.56in 1919mm
Overall Width 4.99ft in 1518mm
Bottom Of Level Bucket, Fully Raised 105.6in 2682mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.