Specification sheet Skid Steer Loader Ref new-holland-l180-skid-steer-loader

New Holland L180

The New Holland L180 is a skid steer loader with an operating weight of 7,095 lb (3,218 kg), a 59 hp engine, a rated operating capacity of 2,200 lb (998 kg), and a tipping load of 4,400 lb (1,995.81 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,095lb
3,218kg
Engine power
59hp
44kW
Net Power
Rated operating capacity
2,200lb
998kg
Tipping load
4,400lb † — value reconstructed from related published figures
1,995.81kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland L180 sits above the median for its class:

  • Operating weight 7,100 lb heavier than 61% (n=334)
  • Engine power 59 hp less powerful than 57% (n=335)
  • Rated operating capacity 2,200 lb higher-rated than 65% (n=288)

◇Scale drawingdrawn to scale · mm

1960B200C3520A
Side elevation
1960B1810D
Front elevation

01 Engine Specification

Engine Make 2249
Engine Model 334M2
Gross Power 63hp 47kw
Net Power 59hp 44kw
Displacement 207.5cu in 3.4L

02 Operational Specification

Operational Weight 7095lb 3218kg
Fuel Capacity 18gal 68.1L
Cooling System Fluid Capacity 4.5gal 17L
Engine Oil Fluid Capacity 2.2gal 8L
Max Speed 6.9mph 11.1km/h
Hydraulic System Fluid Capacity 15gal 56.8L
Chain Box Fluid Capacity - Each Side 2.7gal 10.2L
Operating Speed 11.3mph 18.1km/h
Tire Size 12.0X16.5
Operating Voltage 12V
Alternator Supplied Amperage 95amps

03 Loader Specification

Breakout Force 6034lb 2737kg
Operating Load Rating 2200lb 998kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Type Gear type
Pump Flow Capacity 34.7gal/min 131.4L/min

05 Dimensions Dimensions

Length With Bucket 11.55ft in 3520mm
Width Over Tires 5.94ft in 1810mm
Ground Clearance 7.88in 200mm
Height To Top Of Cab 6.44ft in 1960mm
Wheelbase 4.01ft in 1220mm
Clearance At Max Lift And Dump 12.6ft in 3840mm
Reach At Max Lift And Dump 32.68in 830mm
Turning Radius From Center - Inc Bucket 75.6in 1920mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.