Specification sheet Skid Steer Loader Ref new-holland-l125-skid-steer-loader

New Holland L125

The New Holland L125 is a skid steer loader with an operating weight of 2,185 lb (991.1 kg), a 16.5 hp engine, a rated operating capacity of 698.87 lb (317 kg), and a tipping load of 1,400 lb (635.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,185lb
991.1kg
Engine power
16.5hp
12.4kW
Gross Power
Rated operating capacity
698.87lb
317kg
Tipping load
1,400lb † — value reconstructed from related published figures
635.03kg
Bucket capacity
0.2yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland L125 sits at the compact end of its class:

  • Operating weight 2,190 lb lighter than 98% (n=334)
  • Engine power 17 hp less powerful than 100% (n=335)
  • Rated operating capacity 700 lb lower-rated than 98% (n=288)

◇Scale drawingdrawn to scale · mm

1760B173C2417A
Side elevation
1760B1020D
Front elevation

01 Engine Specification

Number Of Cylinders 3
Engine Make 2249
Engine Model NH673
Gross Power 16.5hp 12.4kw
Power Measured @ 3600rpm
Displacement 41.2cu in 0.7L

02 Operational Specification

Operational Weight 2185lb 991.1kg
Fuel Capacity 6gal 22.7L
Cooling System Fluid Capacity 1.2gal 4.4L
Engine Oil Fluid Capacity 0.9gal 3.1L
Max Speed 5.8mph 9.3km/h
Hydraulic System Fluid Capacity 9gal 34.1L
Tire Size 23X8.50-12
Operating Voltage 12V
Alternator Supplied Amperage 22amps

03 Loader Specification

Breakout Force 1408.8lb 639kg
Operating Load Rating 698.9lb 317kg
Bucket Capacity 0.2yd3 0.2m3

04 Hydraulic Specification

Pump Type Gear type
Pump Flow Capacity 8gal/min 30.2L/min

05 Dimensions Dimensions

Length With Bucket 7.93ft in 2417.07mm
Width Over Tires 3.35ft in 1020mm
Ground Clearance 6.8in 172.72mm
Height To Top Of Cab 5.78ft in 1760mm
Wheelbase 2.66ft in 810mm
Clearance At Max Lift And Dump 1.78ft in 540mm
Reach At Max Lift And Dump 93.71in 2380mm
Turning Radius From Center - Machine Rear 71in 1803.4mm
Turning Radius From Center - Inc Bucket 48in 1219.2mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.