Specification sheet Skid Steer Loader Ref new-holland-l120-skid-steer-loader

New Holland L120

The New Holland L120 is a skid steer loader with an operating weight of 2,050 lb (929.87 kg), a 18 hp engine, a rated operating capacity of 600 lb (272.16 kg), and a tipping load of 1,200 lb (544.31 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,050lb
929.87kg
Engine power
18hp
13.5kW
Gross Power
Rated operating capacity
600lb
272.16kg
Tipping load
1,200lb † — value reconstructed from related published figures
544.31kg
Bucket capacity
0.2yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland L120 sits at the compact end of its class:

  • Operating weight 2,050 lb lighter than 99% (n=334)
  • Engine power 18 hp less powerful than 99% (n=335)
  • Rated operating capacity 600 lb lower-rated than 99% (n=288)

◇Scale drawingdrawn to scale · mm

1762B173C2417A
Side elevation
1762B893D
Front elevation

01 Engine Specification

Number Of Cylinders 2
Engine Make 2355
Engine Model CH18
Gross Power 18hp 13.5kw
Power Measured @ 3600rpm
Displacement 38.1cu in 0.7L

02 Operational Specification

Operational Weight 2050lb 929.9kg
Fuel Capacity 6gal 22.8L
Engine Oil Fluid Capacity 0.9gal 3.1L
Max Speed 5.8mph 9.3km/h
Hydraulic System Fluid Capacity 9.1gal 34.1L
Tire Size 23X8.50-12
Operating Voltage 12V
Alternator Supplied Amperage 20amps

03 Loader Specification

Breakout Force 1408.8lb 639kg
Operating Load Rating 600lb 272.2kg
Bucket Capacity 0.2yd3 0.2m3

04 Hydraulic Specification

Pump Type Gear type
Pump Flow Capacity 8gal/min 30.2L/min
Relief Valve Pressure 1600psi 11025kPa

05 Dimensions Dimensions

Length With Bucket 7.93ft in 2417.07mm
Width Over Tires 2.93ft in 893.07mm
Ground Clearance 6.8in 172.72mm
Height To Top Of Cab 5.78ft in 1761.75mm
Wheelbase 2.44ft in 743.72mm
Clearance At Max Lift And Dump 7.79ft in 2374.4mm
Reach At Max Lift And Dump 5.14in 130.56mm
Turning Radius From Center - Machine Rear 71in 1803.4mm
Turning Radius From Center - Inc Bucket 48in 1219.2mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.