Specification sheet Skid Steer Loader Ref new-holland-c234-skid-steer-loader

New Holland C234

The New Holland C234 is a skid steer loader with an operating weight of 10,000.2 lb (4,536 kg), and a tipping load of 6,799.1 lb (3,084 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
10,000.2lb
4,536kg
Tipping load
6,799.1lb
3,084kg

Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the New Holland C234 sits at the heavy end of its class:

  • Operating weight 10,000 lb heavier than 97% (n=334)

Not positioned on engine power, rated operating capacity — withheld or unpublished for this machine.

01 Engine Specification

Horsepower, Net-Sae J1349 84hp 62.7kw
Fuel Injection HPCR Direct
Horsepower Per Sae J1349 Gross 90hp 67.2kw
Engine Model F5B FL413E
Max Torque 282lb ft 382.4Nm
Torque Measured @ 1400rpm
Displacement 207.5cu in 3.4L
Bore 3.9in 99mm
Stroke 4.3in 109mm

02 Performance Specification

Rated Operating Load, 35% Tip 2381lb 1080kg
Tipping Load 6799.1lb 3084kg
Operating Weight 10000.2lb 4536kg
Breakout Force, Bucket Cylinder 8700.2lb 38.7kN
Breakout Force, Lift Cylinder 7756lb 34.5kN
Rated Operating Load, 50% Tip 3399.6lb 1542kg

03 Power Train Specification

Travel Speed, Low Range 5.1mph 8.2km/h
Travel Speed, High Range 7.6mph 12.2km/h

04 Hydraulic System Specification

Optional High Flow 37.6gal/min 142.4L/min
Relief Valve Pressure 3046psi 21001.5kPa
Pump Flow 24.2gal/min 91.7L/min

05 Dimensions Dimensions

Ground Clearance 9.57in 243mm
Bottom Of Level Bucket, Fully Raised 119.61in 3038mm
Bucket Hinge Pin 126.58in 3215mm
Clearance Circle Rear 67.92in 1725mm
Clearance Circle Without Bucke 57.72in 1466mm
Dump Reach - General Purpose 21.58in 548mm
Ground Pressure 4.41psi 30.34kPa
Overall Width 75.99in 1930mm
Rollback, Bucket At Full Height 99.7degrees
Rollback, Bucket On Ground 29.7degrees
Top Of Rops 80.44in 2043mm
Angle Of Departure 32degrees
Track On Ground 64.53in 1639mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.