Specification sheet Skid Steer Loader Ref mustang-2109-skid-steer-loader

Mustang 2109

The Mustang 2109 is a skid steer loader with an operating weight of 10,520 lb (4,772 kg), a 99 hp engine, a rated operating capacity of 3,850 lb (1,746 kg), and a tipping load of 7,700 lb (3,492.67 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
10,520lb
4,772kg
Engine power
99hp
74kW
Net Power
Rated operating capacity
3,850lb
1,746kg
Tipping load
7,700lb † — value reconstructed from related published figures
3,492.67kg
Bucket capacity
1.1yd³
0.8m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Mustang 2109 sits at the heavy end of its class:

  • Operating weight 10,520 lb heavier than 99% (n=334)
  • Engine power 99 hp more powerful than 99% (n=335)
  • Rated operating capacity 3,850 lb higher-rated than 99% (n=288)

◇Scale drawingdrawn to scale · mm

3607C231D4089A3099B
Side elevation
3607C2057E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2347
Engine Model B4.5T-99C
Net Power 99hp 74kw
Power Measured @ 2200rpm
Displacement 275cu in 4.5L

02 Operational Specification

Operational Weight 10520lb 4772kg
Fuel Capacity 30.5gal 115.4L
Hydraulic System Fluid Capacity 15gal 58L
Max Speed 7.5mph 12km/h
Operating Speed 12.5mph 20km/h
Operating Voltage 12V
Alternator Supplied Amperage 675amps

03 Loader Specification

Operating Load Rating 3850lb 1746kg
Bucket Capacity 1.1yd3 0.8m3

04 Hydraulic Specification

Pump Flow Capacity 41gal/min 155L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Length With Bucket 13.42ft in 4089mm
Width Over Tires 6.75ft in 2057mm
Ground Clearance 9.1in 231mm
Height To Top Of Cab 11.84ft in 3607mm
Wheelbase 4.59ft in 1397mm
Length W/O Bucket 10.17ft in 3099mm
Clearance At Max Lift And Dump 8.92ft in 2718mm
Reach At Max Lift And Dump 38.21in 970mm
Turning Radius From Center - Machine Rear 80.5in 2045mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.