Specification sheet Skid Steer Loader Ref mustang-2076-skid-steer-loader
Mustang 2076
The Mustang 2076 is a skid steer loader with an operating weight of 7,480 lb (3,393 kg), a 84 hp engine, a rated operating capacity of 2,500 lb (1,134 kg), and a 0.5 yd³ (0.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
7,480lb
3,393kg
Engine power
84hp
63kW
Net Power Rated operating capacity
2,500lb
1,134kg
Bucket capacity
0.5yd³
0.4m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Mustang 2076 sits above the median for its class:
- Operating weight 7,480 lb heavier than 68% (n=334)
- Engine power 84 hp more powerful than 87% (n=335)
- Rated operating capacity 2,500 lb higher-rated than 77% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2348 | |
| Engine Model | 4TNV98T / Tier III | |
| Net Power | 84hp | 63kw |
| Power Measured @ | 2500rpm | |
| Aspiration | Turbocharged | |
| Displacement | 202cu in | 3.3L |
02 Operational Specification
| Operational Weight | 7480lb | 3393kg |
|---|---|---|
| Fuel Capacity | 19gal | 72L |
| Hydraulic System Fluid Capacity | 16gal | 60.5L |
| Max Speed | 11.4mph | 18.3km/h |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 950amps |
03 Loader Specification
| Operating Load Rating | 2500lb | 1134kg |
|---|---|---|
| Bucket Capacity | 0.5yd3 | 0.4m3 |
04 Hydraulic Specification
| Pump Flow Capacity | 21.5gal/min | 81L/min |
|---|---|---|
| Relief Valve Pressure | 3000psi | 20684.3kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.76ft in | 3277mm |
|---|---|---|
| Width Over Tires | 5.34ft in | 1626mm |
| Ground Clearance | 7.9in | 201mm |
| Height To Top Of Cab | 6.76ft in | 2060mm |
| Wheelbase | 3.59ft in | 1092mm |
| Length W/O Bucket | 7.75ft in | 2362mm |
| Clearance At Max Lift And Dump | 10.25ft in | 3124mm |
| Reach At Max Lift And Dump | 95in | 2413mm |
| Turning Radius From Center - Machine Rear | 62.6in | 1590mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.