Specification sheet Skid Steer Loader Ref mustang-2054-skid-steer-loader

Mustang 2054

The Mustang 2054 is a skid steer loader with an operating weight of 6,050 lb (2,744 kg), a 47 hp engine, a rated operating capacity of 1,750 lb (794 kg), and a tipping load of 3,300 lb (1,496.86 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,050lb
2,744kg
Engine power
47hp
35kW
Net Power
Rated operating capacity
1,750lb
794kg
Tipping load
3,300lb † — value reconstructed from related published figures
1,496.86kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Mustang 2054 sits below the median for its class:

  • Operating weight 6,050 lb lighter than 69% (n=334)
  • Engine power 47 hp less powerful than 78% (n=335)
  • Rated operating capacity 1,750 lb lower-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

2921C191D3112A2459B
Side elevation
2921C1668E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV88
Net Power 47hp 35kw
Power Measured @ 3000rpm
Displacement 133.6cu in 2.2L

02 Operational Specification

Operational Weight 6050lb 2744kg
Fuel Capacity 14.3gal 54.1L
Hydraulic System Fluid Capacity 13gal 49.2L
Max Speed 7.2mph 11.5km/h
Operating Voltage 12V
Alternator Supplied Amperage 700amps

03 Loader Specification

Operating Load Rating 1750lb 794kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 28gal/min 106L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 10.22ft in 3112mm
Width Over Tires 5.48ft in 1668mm
Ground Clearance 7.5in 191mm
Height To Top Of Cab 9.59ft in 2921mm
Wheelbase 3.21ft in 978mm
Length W/O Bucket 8.07ft in 2459mm
Clearance At Max Lift And Dump 7.67ft in 2337mm
Reach At Max Lift And Dump 24.02in 610mm
Turning Radius From Center - Machine Rear 59.2in 1504mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.