Specification sheet Skid Steer Loader Ref mustang-2044-skid-steer-loader

Mustang 2044

The Mustang 2044 is a skid steer loader with an operating weight of 5,600 lb (2,540 kg), a 47 hp engine, a rated operating capacity of 1,500 lb (703 kg), and a tipping load of 2,900 lb (1,315.42 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,600lb
2,540kg
Engine power
47hp
35kW
Net Power
Rated operating capacity
1,500lb
703kg
Tipping load
2,900lb † — value reconstructed from related published figures
1,315.42kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Mustang 2044 sits below the median for its class:

  • Operating weight 5,600 lb lighter than 76% (n=334)
  • Engine power 47 hp less powerful than 78% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

2845C196D3117A2418B
Side elevation
2845C1626E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV88
Net Power 47hp 35kw
Power Measured @ 3000rpm
Displacement 133.6cu in 2.2L

02 Operational Specification

Operational Weight 5600lb 2540kg
Fuel Capacity 14.3gal 54.1L
Hydraulic System Fluid Capacity 13gal 49.2L
Max Speed 7mph 11.3km/h
Operating Voltage 12V
Alternator Supplied Amperage 700amps

03 Loader Specification

Operating Load Rating 1500lb 703kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 18gal/min 68.1L/min
Relief Valve Pressure 2500psi 17236.9kPa

05 Dimensions Dimensions

Length With Bucket 10.23ft in 3117mm
Width Over Tires 5.34ft in 1626mm
Ground Clearance 7.7in 196mm
Height To Top Of Cab 9.34ft in 2845mm
Wheelbase 3.06ft in 932mm
Length W/O Bucket 7.94ft in 2418mm
Clearance At Max Lift And Dump 7.36ft in 2242mm
Reach At Max Lift And Dump 88.2in 2245mm
Turning Radius From Center - Machine Rear 50.5in 1283mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.