Specification sheet Skid Steer Loader Ref mustang-2041-skid-steer-loader

Mustang 2041

The Mustang 2041 is a skid steer loader with an operating weight of 4,600 lb (2,087 kg), a 46 hp engine, a rated operating capacity of 1,475 lb (669 kg), and a tipping load of 2,700 lb (1,224.7 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,600lb
2,087kg
Engine power
46hp
34kW
Net Power
Rated operating capacity
1,475lb
669kg
Tipping load
2,700lb † — value reconstructed from related published figures
1,224.7kg
Bucket capacity
0.4yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Mustang 2041 sits at the compact end of its class:

  • Operating weight 4,600 lb lighter than 89% (n=334)
  • Engine power 46 hp less powerful than 82% (n=335)
  • Rated operating capacity 1,480 lb lower-rated than 78% (n=288)

◇Scale drawingdrawn to scale · mm

2794C2951A2314B
Side elevation
2794C1483D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV88
Net Power 46hp 34kw
Power Measured @ 2600rpm
Displacement 134cu in 2.2L

02 Operational Specification

Operational Weight 4600lb 2087kg
Fuel Capacity 12.4gal 46.9L
Hydraulic System Fluid Capacity 10gal 37.8L
Max Speed 6.4mph 10.3km/h
Operating Voltage 12V
Alternator Supplied Amperage 650amps

03 Loader Specification

Operating Load Rating 1475lb 669kg
Bucket Capacity 0.4yd3 0.3m3

04 Hydraulic Specification

Pump Flow Capacity 16.5gal/min 62.5L/min
Relief Valve Pressure 2750psi 18960.6kPa

05 Dimensions Dimensions

Length With Bucket 9.69ft in 2951mm
Width Over Tires 4.87ft in 1483mm
Height To Top Of Cab 9.17ft in 2794mm
Wheelbase 3.06ft in 932mm
Length W/O Bucket 7.6ft in 2314mm
Clearance At Max Lift And Dump 7.21ft in 2197mm
Reach At Max Lift And Dump 8.31in 211mm
Turning Radius From Center - Machine Rear 58.4in 1483mm
Turning Radius From Center - Inc Bucket 69.2in 1758mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.