Specification sheet Skid Steer Loader Ref mustang-2026-skid-steer-loader
Mustang 2026
The Mustang 2026 is a skid steer loader with an operating weight of 4,000 lb (1,814 kg), a 35 hp engine, a rated operating capacity of 1,175 lb (532 kg), and a 0.4 yd³ (0.3 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
4,000lb
1,814kg
Engine power
35hp
26kW
Gross Power Rated operating capacity
1,175lb
532kg
Bucket capacity
0.4yd³
0.3m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Mustang 2026 sits at the compact end of its class:
- Operating weight 4,000 lb lighter than 92% (n=334)
- Engine power 35 hp less powerful than 92% (n=335)
- Rated operating capacity 1,180 lb lower-rated than 91% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 3 | |
|---|---|---|
| Engine Make | 2348 | |
| Engine Model | 3TNV88 | |
| Gross Power | 35hp | 26kw |
| Power Measured @ | 2600rpm | |
| Displacement | 100cu in | 1.6L |
02 Operational Specification
| Operational Weight | 4000lb | 1814kg |
|---|---|---|
| Fuel Capacity | 10.3gal | 39L |
| Max Speed | 6.8mph | 10.9km/h |
| Hydraulic System Fluid Capacity | 10gal | 37.8L |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 650amps |
03 Loader Specification
| Operating Load Rating | 1175lb | 532kg |
|---|---|---|
| Bucket Capacity | 0.4yd3 | 0.3m3 |
04 Hydraulic Specification
| Pump Flow Capacity | 14.5gal/min | 55L/min |
|---|---|---|
| Relief Valve Pressure | 2750psi | 18960.6kPa |
05 Dimensions Dimensions
| Length With Bucket | 9.51ft in | 2896mm |
|---|---|---|
| Width Over Tires | 4.69ft in | 1428mm |
| Ground Clearance | 6in | 152mm |
| Height To Top Of Cab | 9ft in | 2743mm |
| Wheelbase | 2.88ft in | 876mm |
| Length W/O Bucket | 7.42ft in | 2261mm |
| Clearance At Max Lift And Dump | 7.05ft in | 2146mm |
| Reach At Max Lift And Dump | 22.8in | 579mm |
| Turning Radius From Center - Machine Rear | 54.1in | 1374mm |
| Turning Radius From Center - Inc Bucket | 69.41in | 1763mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.