Specification sheet Wheel Loader Ref mecalac-ax-700-wheel-loader
Mecalac AX 700
The Mecalac AX 700 is a wheel loader with an operating weight of 10,383.78 lb (4,710 kg), a 68 hp engine, and a 1.57 yd³ (1.2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
10,383.78lb
4,710kg
Engine power
68hp
50.8kW
Net Power Bucket capacity
1.57yd³
1.2m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Mecalac AX 700 sits below the median for its class:
- Operating weight 10,380 lb lighter than 70% (n=374)
- Engine power 68 hp less powerful than 55% (n=367)
- Bucket capacity 1.6 yd³ larger-bucket than 59% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Model | Deutz TD 2.9 L4 | |
|---|---|---|
| Net Power | 68hp | 50.8kw |
| Power Measured @ | 2300rpm | |
| Max Torque | 234 Nm | |
| Battery | 100 Ah | |
| Torque Measured @ | 1800rpm | |
| Aspiration | Low-noise, water-cooled, turbo diesel engine |
02 Operational Specification
| Operating Weight | 10383.8lb | 4710kg |
|---|---|---|
| Fuel Capacity | 23gal | 87L |
| Hydraulic System Fluid Capacity | 15.9gal | 60L |
| Front Axle/Diff Fluid Capacity | 1.6gal | 5.9L |
| Rear Axle/Diff Fluid Capacity | 1.8gal | 6.8L |
| Steering Angle | 40degrees | |
| Turning Radius | 12.2ft in | 3700mm |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 95amps | |
| Rear Axle Oscillation | 11degrees | |
| Tire Size | 12.5-18 |
03 Transmission Specification
| Max Speed - Forward | 12.5mph | 20km/h |
|---|
04 Hydraulic System Specification
| Pump Flow Capacity | 16.4gal/min | 62L/min |
|---|---|---|
| Pump Type | Single circuit hydraulics with central gear pump |
05 Bucket Dimensions
| Breakout Force | 3500 daN | |
|---|---|---|
| Bucket Capacity - Heaped | 1.57yd3 | 1.2m3 |
| Dumping Angle, Top | 45degrees | |
| Lifting Force | 3500 daN | |
| Payload On Forks, Max. Turned, Frontal | 4629.71lb | 2100kg |
| Thrust Force | 3800 daN | |
| Tipping Load Standard Bucket | 7054.8lb | 3200kg |
06 Dimensions Dimensions
| Ground Clearance | 1.38ft in | 420mm |
|---|---|---|
| Length With Bucket On Ground | 17.34ft in | 5285mm |
| Width Over Tires | 5.25ft in | 1600mm |
| Height To Top Of Cab | 8.11ft in | 2470mm |
| Wheelbase | 6.67ft in | 2030mm |
| Hinge Pin - Max Height | 10.75ft in | 3275mm |
| Reach At Max Lift And Dump | 2.56ft in | 780mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.