Specification sheet Wheel Loader Ref mecalac-af-1200-wheel-loader

Mecalac AF 1200

The Mecalac AF 1200 is a wheel loader with an operating weight of 13,227.74 lb (6,000 kg), a 75 hp engine, and a 2.62 yd³ (2 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
13,227.74lb
6,000kg
Engine power
75hp
56kW
Net Power
Bucket capacity
2.62yd³
2m³

Where it sits in its classpercentile · compact wheel loaders

Among 374 compact wheel loaders (≤22,000 lb), the Mecalac AF 1200 sits in the middle of its class:

  • Operating weight 13,230 lb heavier than 56% (n=374)
  • Engine power 75 hp more powerful than 56% (n=367)
  • Bucket capacity 2.6 yd³ larger-bucket than 95% (n=309)

Scale drawingdrawn to scale · mm

2840B420C6080A
Side elevation
2840B2060D
Front elevation

01 Engine Specification

Engine Model Deutz TCD 2.9 L4
Net Power 75hp 56kw
Power Measured @ 2600rpm
Max Torque 300 Nm
Battery 95 Ah
Torque Measured @ 1600rpm
Aspiration Low-noise, water-cooled, turbo diesel engine

02 Operational Specification

Operating Weight 13227.8lb 6000kg
Fuel Capacity 34.4gal 130L
Hydraulic System Fluid Capacity 35.4gal 134L
Front Axle/Diff Fluid Capacity 3gal 11L
Rear Axle/Diff Fluid Capacity 3.2gal 12L
Steering Angle 35degrees
Turning Radius 12.2ft in 3700mm
Operating Voltage 12V
Rear Axle Oscillation 10degrees
Tire Size 16/17-20

03 Transmission Specification

Max Speed - Forward 12.5mph 20km/h

04 Hydraulic System Specification

Pump Flow Capacity 22.2gal/min 84L/min
Pump Type Single circuit hydraulics with central gear pump

05 Bucket Dimensions

Breakout Force 4900 daN
Bucket Capacity - Heaped 2.62yd3 2m3
Dumping Angle, Top 45degrees
Lifting Force 6600 daN
Payload On Forks, Max. Turned, Frontal 6327.27lb 2870kg
Thrust Force 4650 daN
Tipping Load Standard Bucket 9479.88lb 4300kg

06 Dimensions Dimensions

Ground Clearance 1.38ft in 420mm
Length With Bucket On Ground 19.95ft in 6080mm
Width Over Tires 6.76ft in 2060mm
Height To Top Of Cab 9.32ft in 2840mm
Wheelbase 6.85ft in 2085mm
Hinge Pin - Max Height 11.98ft in 3650mm
Reach At Max Lift And Dump 2.43ft in 740mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.