Specification sheet Wheel Loader Ref liebherr-l566-xpower-wheel-loader
Liebherr L566 XPOWER
The Liebherr L566 XPOWER is a wheel loader with an operating weight of 52,690 lb (23,899.79 kg), a 268 hp engine, a 5.5 yd³ (4.21 m³) bucket, and a dig depth of 4 ft (1,219.2 mm).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
52,690lb
23,899.79kg
Engine power
268hp
199.9kW
Net Power Bucket capacity
5.5yd³
4.21m³
Dig depth
4ft
1,219.2mm
◆Where it sits in its classpercentile · medium wheel loaders
Among 198 medium wheel loaders (45,000–90,000 lb), the Liebherr L566 XPOWER sits in the middle of its class:
- Operating weight 52,690 lb lighter than 51% (n=198)
- Engine power 268 hp less powerful than 59% (n=190)
- Bucket capacity 5.5 yd³ smaller-bucket than 56% (n=174)
◇Scale drawingdrawn to scale · mm
01 Electrical System Specification
| Alternator | 28/180 (V/A) | |
|---|---|---|
| Voltage | 24 VV | |
| Starter | 24/10.5 (V/HP) | |
| Battery | 2 x 180 Ah |
02 Engine Specification
| Fuel Injection | Electronic Common Rail high-pressure injection | |
|---|---|---|
| Number Of Cylinders | 6 | |
| Engine Model | D936 A7 | |
| Net Power | 268hp | 199.9kw |
| Air Cleaner | Dry type filter with main and safety element, pre-cleaner, service indicator on the Liebherr display | |
| Gross Power | 272hp | 202.9kw |
| Power Measured @ | 1800rpm | |
| Max Torque | 1409 lb ft | |
| Displacement | 642cu in | 10.6L |
| Torque Measured @ | 1100rpm | |
| Aspiration | Water-cooled in-line engine with charge-air cooling, exhaust after-treatment through Liebherr-SCR technology | |
| Bore | 4.8in | 122mm |
| Stroke | 6in | 150.2mm |
03 Operational Specification
| Operating Weight | 52690lb | 23899.8kg |
|---|---|---|
| Fuel Capacity | 96gal | 363.4L |
| Hydraulic System Fluid Capacity | 50.2gal | 190.1L |
| Engine Oil Fluid Capacity | 10.6gal | 40.2L |
| Cooling System Fluid Capacity | 19.3gal | 73.1L |
| Hydraulic Fluid Capacity | 27.7gal | 104.9L |
| Front Axle/Diff Fluid Capacity | 11.1gal | 42.1L |
| Rear Axle/Diff Fluid Capacity | 11.1gal | 42.1L |
| Static Tipping Weight | 35055lb | 15900.7kg |
| Turning Radius | 24.1ft in | 7345.7mm |
| Tire Size | 26.5R25 L3 |
04 Transmission Specification
| Max Speed - Forward | 24.9mph | 40.1km/h |
|---|---|---|
| Max Speed - Reverse | 24.9mph | 40.1km/h |
05 Hydraulic System Specification
| Max Operating Pressure | 5076 psi | |
|---|---|---|
| Relief Valve Setting | 4351.2psi | 30000kPa |
| Pump Flow Capacity | 77gal/min | 291.5L/min |
| Raise Time | 5.5sec | |
| Dump Time | 2sec | |
| Lower Time | 3.5sec | |
| Pump Type | “Load-sensing” variable axial piston pump with output and flow control, and pressure cut-off in the control block |
06 Bucket Dimensions
| Dump Clearance At Max Raise | 10.6ft in | 3230.88mm |
|---|---|---|
| Arm Length | 9.7ft in | 2956.56mm |
| Breakout Force | 44959.54lb | 199.99kN |
| Bucket Capacity - Heaped | 5.5yd3 | 4.21m3 |
| Bucket Width | 9.1ft in | 2773.68mm |
| Digging Depth | 4ft in | 1219.2mm |
07 Dimensions Dimensions
| Ground Clearance | 1.9ft in | 579.12mm |
|---|---|---|
| Length With Bucket On Ground | 30.1ft in | 9174.48mm |
| Height To Top Of Cab | 11.9ft in | 3627.12mm |
| Wheelbase | 11.8ft in | 3596.64mm |
| Hinge Pin - Max Height | 14.4ft in | 4389.12mm |
| Reach At Max Lift And Dump | 3.11ft in | 947.93mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.