Specification sheet Wheel Loader Ref liebherr-l524-wheel-loader
Liebherr L524
The Liebherr L524 is a wheel loader with an operating weight of 22,930 lb (10,400.88 kg), a 121 hp engine, a 2.4 yd³ (1.84 m³) bucket, and a dig depth of 2 ft (609.6 mm).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
22,930lb
10,400.88kg
Engine power
121hp
90.23kW
Gross Power Bucket capacity
2.4yd³
1.84m³
Dig depth
2ft
609.6mm
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Liebherr L524 sits at the compact end of its class:
- Operating weight 22,930 lb lighter than 95% (n=439)
- Engine power 121 hp less powerful than 89% (n=408)
- Bucket capacity 2.4 yd³ smaller-bucket than 85% (n=387)
◇Scale drawingdrawn to scale · mm
01 Electrical System Specification
| Alternator | 24/100 (V/A) | |
|---|---|---|
| Voltage | 24 VV | |
| Starter | 24/10.5 (V/HP) | |
| Battery | 2 x 135 Ah |
02 Engine Specification
| Fuel Injection | Electronic Common Rail high-pressure injection | |
|---|---|---|
| Number Of Cylinders | 4 | |
| Engine Make | 2245 | |
| Engine Model | 4045HFL92 | |
| Air Cleaner | Dry air filter with main and safety element, pre-cleaner, service indicator on the display | |
| Gross Power | 121hp | 90.3kw |
| Power Measured @ | 2000rpm | |
| Max Torque | 354 lb ft | |
| Displacement | 275cu in | 4.6L |
| Torque Measured @ | 1600rpm | |
| Aspiration | Inline engine, water-cooled, turbo-charged | |
| Bore | 4.2in | 106.7mm |
| Stroke | 5in | 127mm |
03 Operational Specification
| Operating Weight | 22930lb | 10400.9kg |
|---|---|---|
| Fuel Capacity | 54.2gal | 205.2L |
| Hydraulic System Fluid Capacity | 44.9gal | 170L |
| Engine Oil Fluid Capacity | 3.9gal | 14.8L |
| Cooling System Fluid Capacity | 10gal | 37.9L |
| Transmission Fluid Capacity | 1gal | 3.8L |
| Hydraulic Fluid Capacity | 29gal | 109.8L |
| Front Axle/Diff Fluid Capacity | 4.3gal | 16.3L |
| Rear Axle/Diff Fluid Capacity | 4gal | 15.2L |
| Static Tipping Weight | 16535lb | 7500.2kg |
| Turning Radius | 19ft in | 5791.2mm |
| Rear Axle Oscillation | 12degrees | |
| Tire Size | 17.5R25 L3 |
04 Transmission Specification
| Transmission Type | Stepless hydrostatic travel drive | |
|---|---|---|
| Number Of Forward Gears | 3 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 24.9mph | 40.1km/h |
| Max Speed - Reverse | 20.6mph | 33km/h |
05 Hydraulic System Specification
| Max Operating Pressure | 4569 psi | |
|---|---|---|
| Relief Valve Setting | 4351.2psi | 30000kPa |
| Pump Flow Capacity | 27gal/min | 102.3L/min |
| Raise Time | 6.5sec | |
| Dump Time | 2sec | |
| Lower Time | 5sec | |
| Pump Type | Load-Sensing, variable axial piston pump with output control and pressure cutoff |
06 Bucket Dimensions
| Dump Clearance At Max Raise | 9.2ft in | 2804.16mm |
|---|---|---|
| Arm Length | 8.2ft in | 2499.36mm |
| Breakout Force | 18210lb | 81.01kN |
| Bucket Capacity - Heaped | 2.4yd3 | 1.84m3 |
| Bucket Width | 8.2ft in | 2499.36mm |
| Digging Depth | 2ft in | 609.6mm |
07 Dimensions Dimensions
| Ground Clearance | 1.6ft in | 487.68mm |
|---|---|---|
| Length With Bucket On Ground | 23.5ft in | 7162.8mm |
| Height To Top Of Cab | 10.6ft in | 3230.88mm |
| Wheelbase | 9.4ft in | 2865.12mm |
| Hinge Pin - Max Height | 12.7ft in | 3870.96mm |
| Reach At Max Lift And Dump | 3.5ft in | 1066.8mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.