Specification sheet Wheel Loader Ref liebherr-l524-2plus1-wheel-loader
Liebherr L524 2plus1
The Liebherr L524 2plus1 is a wheel loader with an operating weight of 22,825 lb (10,353.25 kg), a 115.33 hp engine, and a 2.62 yd³ (2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
22,825lb
10,353.25kg
Engine power
115.33hp
86kW
Gross Power Bucket capacity
2.62yd³
2m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Liebherr L524 2plus1 sits at the compact end of its class:
- Operating weight 22,830 lb lighter than 95% (n=439)
- Engine power 115 hp less powerful than 95% (n=408)
- Bucket capacity 2.6 yd³ smaller-bucket than 76% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2245 | |
| Engine Model | D 504 Tl | |
| Gross Power | 115.4hp | 86kw |
| Power Measured @ | 2400rpm | |
| Max Torque | 317.2lb ft | 430Nm |
| Displacement | 274.7cu in | 4.5L |
| Torque Measured @ | 1500rpm | |
| Aspiration | turbo-charged |
02 Operational Specification
| Operating Weight | 22825lb | 10353.3kg |
|---|---|---|
| Fuel Capacity | 45gal | 170L |
| Hydraulic System Fluid Capacity | 45gal | 170L |
| Engine Oil Fluid Capacity | 3.2gal | 12L |
| Front Axle/Diff Fluid Capacity | 4.4gal | 16.3L |
| Rear Axle/Diff Fluid Capacity | 4gal | 15L |
| Static Tipping Weight | 16100lb | 7302.9kg |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 55amps | |
| Rear Axle Oscillation | 12degrees | |
| Tire Size | 17.5R25 |
03 Transmission Specification
| Transmission Type | hydrostatic | |
|---|---|---|
| Number Of Forward Gears | 3 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 24.9mph | 40km/h |
| Max Speed - Reverse | 24.9mph | 40km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 4568.7psi | 31500kPa |
|---|---|---|
| Pump Flow Capacity | 27.8gal/min | 105L/min |
| Raise Time | 6.6sec | |
| Dump Time | 1.8sec | |
| Lower Time | 4sec | |
| Pump Type | Load-sensing variable axial piston pump with output and flow controls, and pressure cut-off in the control block |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.42ft in | 2870mm |
|---|---|---|
| Breakout Force | _- | 91kN |
| Bucket Capacity - Heaped | 2.62yd3 | 2m3 |
| Bucket Width | 8.21ft in | 2500mm |
06 Dimensions Dimensions
| Ground Clearance | 1.51ft in | 460mm |
|---|---|---|
| Length With Bucket On Ground | 22.05ft in | 6720mm |
| Height To Top Of Cab | 10.5ft in | 3200mm |
| Wheelbase | 9.03ft in | 2750mm |
| Hinge Pin - Max Height | 12.39ft in | 3775mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.