Specification sheet Wheel Loader Ref komatsu-wa470-3-active-plus-wheel-loader
Komatsu WA470-3 Active+
The Komatsu WA470-3 Active+ is a wheel loader with an operating weight of 51,522.04 lb (23,370 kg), a 263 hp engine, and a 5.5 yd³ (4.2 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
51,522.04lb
23,370kg
Engine power
263hp
196.12kW
Gross Power Bucket capacity
5.5yd³
4.2m³
◆Where it sits in its classpercentile · medium wheel loaders
Among 198 medium wheel loaders (45,000–90,000 lb), the Komatsu WA470-3 Active+ sits in the middle of its class:
- Operating weight 51,520 lb lighter than 60% (n=198)
- Engine power 263 hp less powerful than 67% (n=190)
- Bucket capacity 5.5 yd³ smaller-bucket than 56% (n=174)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2238 | |
| Engine Model | SA6D135E | |
| Gross Power | 263hp | 196.2kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 773.8lb ft | 1049Nm |
| Displacement | 674.1cu in | 11.1L |
| Torque Measured @ | 1400rpm |
02 Operational Specification
| Operating Weight | 51522.1lb | 23370kg |
|---|---|---|
| Fuel Capacity | 103.1gal | 390L |
| Hydraulic System Fluid Capacity | 63.5gal | 240L |
| Engine Oil Fluid Capacity | 8.8gal | 33L |
| Cooling System Fluid Capacity | 18gal | 68L |
| Transmission Fluid Capacity | 13.8gal | 52L |
| Front Axle/Diff Fluid Capacity | 17.2gal | 65L |
| Rear Axle/Diff Fluid Capacity | 17.2gal | 65L |
| Static Tipping Weight | 40366.7lb | 18310kg |
| Turning Radius | 20.3ft in | 6175mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 50amps | |
| Rear Axle Oscillation | 30degrees | |
| Tire Size | 26.5 R25 XHA L3, Michelin |
03 Transmission Specification
| Transmission Type | fully automatic 4-speed full powershift with 'kickdown' and 'gear-hold' | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 24.3mph | 39km/h |
| Max Speed - Reverse | 23.4mph | 37.5km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3045.8psi | 21000kPa |
|---|---|---|
| Pump Flow Capacity | 104.9gal/min | 397L/min |
| Raise Time | 6.8sec | |
| Dump Time | 1.4sec | |
| Lower Time | 3.7sec |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.85ft in | 3000mm |
|---|---|---|
| Bucket Capacity - Heaped | 5.5yd3 | 4.2m3 |
| Bucket Width | 9.85ft in | 3000mm |
| Breakout Force | 40915.23lb | 182kN |
06 Dimensions Dimensions
| Ground Clearance | 1.61ft in | 490mm |
|---|---|---|
| Length With Bucket On Ground | 28.2ft in | 8594mm |
| Width Over Tires | 9.47ft in | 2885mm |
| Height To Top Of Cab | 11.41ft in | 3475mm |
| Wheelbase | 11.16ft in | 3400mm |
| Hinge Pin - Max Height | 13.85ft in | 4220mm |
| Reach At Max Lift And Dump | 4.19ft in | 1276mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.